In this research, drone-based photogrammetry was utilized for mapping geology with the objective of mineral exploration in the Shahzadeh Abbas Cu deposit, Kerman province, Iran. Cu mineralization is of vein-type and follows geological structures. A low-cost drone was used to collect geological data. A spatial resolution of 3.26 cm was achieved by considering a flight altitude of 70 m. To reach the accuracy of less than 5 cm, 70% lateral and 80% front image overlaps were applied and 220 temporary ground control points (TGCPs) were used in an area of 2.02 km2. TGCPs were accurately positioned using DGPS-RTK measurements. Agisoft PhotoScan software was used for photogrammetric processing. The orthophoto product was performed for outlining geological units through visual interpretation. The digital elevation model (DEM) was converted to a hill-shade model in ArcGIS software to extract the geological structures such as faults and dikes. A draft geology map was prepared using orthophoto and hill-shade images to minimize the time and cost of the subsequent field work. Rock sampling was carried out and Cu-bearing veins were specified through field investigations. The geology map was finalized based on field work data and petrology studies. The geological survey indicated that diabase dikes with a northwest–southeast strike often host Cu mineralization in the study area. The position of Cu-bearing dikes was delineated for the next stage of the exploration program. This research demonstrated the time- and cost-effectiveness of using drone-based photogrammetry for preparing base geology maps for the exploration of vein-type mineralization in far districts with rough topography.
24 February 2015 in International Journal of Remote Sensing
The shortwave infrared (SWIR) spectral bands of four multi-temporal images acquired by the Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) on NASA’s Terra platform were analysed for evaluating the effects of acquisition properties and atmospheric pre-processing levels on the resulting hydrothermal alteration maps a using the fractal-aided Spectral Angle Mapper (SAM) method. Three ASTER level-1B products covering the Sar Cheshmeh area in Iran were used for hydrothermal alteration mapping. These images were converted to surface reflectance using the Fast Line-of-sight Atmospheric Analysis of Spectral Hypercubes (FLAASH) method. The low reflectance of band 5 of the level-1B products was compensated for by using the spectra of collected rock samples. Level-2 (AST2B05S) SWIR ASTER images that had already been processed were also used. Reference spectra of the main hydrothermal alteration types were extracted for each product. The threshold angles were determined using the real value–area (RV–A) fractal technique. Then, SAM classification was carried out to map hydrothermal alteration for every product. It is concluded that the level-1B products that had been converted to reflectances have a better spectral contrast than the AST2B05S product. Summer images with lower tilt angle and higher solar elevation should be used to increase the accuracy of the image classification and minimize the effect of vegetation on the spectra of index minerals. By comparing the resulting hydrothermal alteration maps with known alteration types using a confusion matrix, it was shown that the application of the RV–A fractal technique to produce less biased threshold angles increases the accuracy of SAM classification.
The Ravar-Kuhbanan-Bahabad belt (RKBB) in Central Iran contains several carbonate-hosted non-sulphide Zn (zinc)-Pb (lead) deposits. The Gujer Zn mine area located in the middle of the RKBB was selected as the case study. Due to its large extent, dolomitic envelope in carbonate host rocks can be considered as a more appropriate exploratory target than small Zn-rich gossans or blind karst filling ore. Based on previous studies, the occurrence of red sandstone as a candidate of supplying metal for mineralization and evaporate as sulphate source for mineralized liquids in the vicinity of carbonate rocks can be important exploratory key in the RKBB. Non-sulphide Zn deposits were formed through oxidation of primary Mississippi Valley-type (MVT) deposits in the study area. Remote sensing studies were undertaken using visible to near-infrared (VNIR) and shortwave infrared (SWIR) bands of the Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) with the objective of lithological mapping. Five traverse lines containing a total of 81 samples were designed and followed with subsequent chemical analysis, thin section studies, and spectroscopy to verify the results. Two types of carbonates, namely, magnesian dolomite as host rock and surrounding calcitic limestone, were realized through using magnesium oxide (MgO) to calcium oxide (CaO) ratio. Based on spectroscopy studies, calcite and dolomite showed distinct absorption features at 2.35 µm and 2.32 µm, respectively, in ASTER band 8 while a shoulder at 2.25 µm was seen in ASTER band 7 for dolomite. Three image processing methods including spectral angle mapper (SAM), linear spectral unmixing (LSU), and mixture-tuned matched-filtering (MTMF) were applied to separate dolomite and limestone. The accuracy of image classification was numerically estimated using a confusion matrix. Limestone with the accuracy of 95.83% was more precisely enhanced using MTMF method compared to SAM and LSU methods. Highest accuracy of 75% for dolomite was obtained through using LSU method. Red sandstone and evaporate units were classified using MTMF and SAM/LSU methods, respectively. Rock units with the highest accuracy were selected and simply overlain on an image of ASTER in a GIS platform to create the potential map of the study area. Results showed that ASTER data can be successfully used to prepare a potential map for regional scale prospecting for carbonate-hosted non-sulphide Zn-Pb deposits in geological setting and climate condition similar to the RKBB.
15 May 2024 in Journal of the Indian Society of Remote Sensing