Andrew Garmory

Andrew Garmory


Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2011 in Proceedings of the Combustion Institute
Verified
Journal Article
Open access
AGAndrew Garmory
Andrew Garmory
EMEpaminondas Mastorakos
Epaminondas Mastorakos
A Large Eddy Simulation (LES) using the Conditional Moment Closure (CMC) as a sub-grid turbulence-chemistry model has been applied to piloted jet diffusion flames (Sandia D&F). A 3D CMC grid was used which allowed different CMC boundary conditions to be applied in the jet and pilot streams. The code was found to give very good agreement with experiment in the low extinction case of Flame D. For Flame F transient extinction and re-ignition events were observed with LES–CMC which lead to reductions in averaged unconditional and conditional temperature consistent with experimental observations. Further analysis revealed that the CMC extinction/ignition events were the result of a combination of high conditional scalar dissipation rate and transport in the CMC grid.

1 May 2017 in International Journal of Multiphase Flow
Verified
Journal Article
Open access
MDM. Dianat
M. Dianat
MSM. Skarysz
M. Skarysz
AGAndrew Garmory
Andrew Garmory
This is an Open Access Article. It is published by Elsevier under the Creative Commons Attribution 4.0 Unported Licence (CC BY). Full details of this licence are available at: http://creativecommons.org/licenses/by/4.0/Motivated by the need for practical, high fidelity, simulation of water over surface features of road vehicles a Coupled Level Set Volume of Fluid (CLSVOF) method has been implemented into a general purpose CFD code. It has been implemented such that it can be used with unstructured and non-orthogonal meshes. The interface reconstruction step needed for CLSVOF has been implemented using an iterative ‘clipping and capping’ algorithm for arbitrary cell shapes and a reinitialisation algorithm suitable for unstructured meshes is also presented. Successful verification tests of interface capturing on orthogonal and tetrahedral meshes are presented. Two macroscopic contact angle models have been implemented and the method is seen to give very good agreement with experimental data for a droplet impinging on a flat plate for both orthogonal and non-orthogonal meshes. Finally the flow of a droplet over a round edged channel is simulated in order to demonstrate the ability of the method developed to simulate surface flows over the sort of curved geometry that makes the use of a non-orthogonal grid desirable

1 February 2009 in Atmospheric Environment
Verified
Journal Article
Closed access
Prashant KumarPrashant Kumar
Prashant Kumar
AGAndrew Garmory
Andrew Garmory
MKMatthias KETZEL
Matthias KETZEL
RBRuwim Berkowicz
Ruwim Berkowicz
RBRex Britter
Rex Britter

1 January 2015 in Proceedings of the Combustion Institute
Verified
Journal Article
Closed access
HZHuangwei Zhang
Huangwei Zhang
AGAndrew Garmory
Andrew Garmory
DCDavide E. Cavaliere
Davide E. Cavaliere
EMEpaminondas Mastorakos
Epaminondas Mastorakos

1 September 2015 in Journal of Sound and Vibration
Verified
Journal Article
Open access
JSJ. Su
J. Su
JRJ. Rupp
J. Rupp
AGAndrew Garmory
Andrew Garmory
JCJ.F. Carrotte
J.F. Carrotte
This is an Open Access Article. It is published by Elsevier under the Creative Commons Attribution 4.0 Unported Licence (CC BY). Full details of this licence are available at: http://creativecommons.org/licenses/by/4.0/The response of orifices to incident acoustic waves, which is important for many engineering applications, is investigated with an approach combining both experimental measurements and numerical simulations. This paper presents experimental data on acoustic impedance of orifices, which is subsequently used for validation of a numerical technique developed for the purpose of predicting the acoustic response of a range of geometries with moderate computational cost. Measurements are conducted for orifices with length to diameter ratios, L/D, of 0.5, 5 and 10. The experimental data is obtained for a range of frequencies using a configuration in which a mean (or bias) flow passes from a duct through the test orifices before issuing into a plenum. Acoustic waves are provided by a sound generator on the upstream side of the orifices. Computational fluid dynamics (CFD) calculations of the same configuration have also been performed. These have been undertaken using an unsteady Reynolds averaged Navier–Stokes (URANS) approach with a pressure based compressible formulation with appropriate characteristic based boundary conditions to simulate the correct acoustic behaviour at the boundaries. The CFD predictions are in very good agreement with the experimental data, predicting the correct trend with both frequency and orifice L/D in a way not seen with analytical models. The CFD was also able to successfully predict a negative resistance, and hence a reflection coefficient greater than unity for the L/D=0.5L/D=0.5 case

1 October 2009 in Atmospheric Environment
Verified
Journal Article
Open access
AGAndrew Garmory
Andrew Garmory
IKI.S. Kim
I.S. Kim
RBR.E. Britter
R.E. Britter
EMEpaminondas Mastorakos
Epaminondas Mastorakos
This article was published in the journal, Atmospheric Environment [© Elsevier Ltd.] and the definitive version is available at: http://dx.doi.org/10.1016/j.atmosenv.2008.07.033The Stochastic Fields (SF) or Field Monte Carlo method has been used to model the dispersion of reactive scalars in a street canyon, using a simple chemistry and the CBM-IV mechanism. SF is a Probability Density Function (PDF) method which allows both means and variances of the scalars to be calculated as well as considering the effect of segregation on reaction rates. It was found that the variance of reactive scalars such as NO2 was very high in the mixing region at roof-top level with rms values of the order of the mean values. The effect of segregation on major species such as O3 was found to be very small using either mechanism, however, some radical species in CBM-IV showed a significant difference. These were found to be the seven species with the fastest chemical timescales. The calculated photostationary state defect was also found to be in error when segregation is neglected