Equation of state of gold (Au) is revised using the remeasured shock compression data at pressures up to 580 GPa with including the electronic free-energy contribution. The model, even though determined only using pressure-scale-free data, can reproduce not only the shock compression data but also the zero-pressure thermodynamic properties with remarkable accuracy. Previous models for the EOS of copper, silver, and MgO that were constructed using as a basis old shock compression data are found to underestimate the pressure seriously (up to at 200 GPa and 300 K). Moreover, we redetermine the EOS model of platinum (Pt) through the same procedure. The determined models of Au and Pt are found mutually highly consistent, which provide quite comparable pressure values in extensive , range. These are expected to be more reliable primary pressure standards than previous models.
First-order Raman scattering from graphite irradiated by an electron beam has been studied by using the laser microprobe technique. An approximately linear relation is exhibited between the linewidth of the mode and the reciprocal of the crystallite size. The observed linewidths are larger than those calculated by using the known dispersion curve and the wave-vector uncertainty.
Real-time Raman measurements have been performed on graphite under 3-keV -ion irradiation with a time resolution of 6 sec. Ion flux of 3× and 4× ions/ sec are used. The graphite lattice damage is estimated by the relative intensity ratio of the disorder-induced peak (∼1360 ) with respect to the Raman-active -mode peak (∼1580 ). The relative intensity change in the Raman spectrum caused by the irradiation is explained in terms of a reduction in the phonon correlation length due to defects.
The dependence on laser intensity and pulse duration in energetic proton acceleration by irradiation of ultrashort laser pulses on a thick copper tape target was measured. The laser intensity was varied from to , and the pulse duration from 55 fs to 400 fs. The maximum proton energy increased as the pulse duration was increased while the laser intensity was kept constant. The dependence of the maximum proton energy on laser intensity and pulse duration was in good agreement with an analytical plasma-expanding model.
Hard x-ray generation from tera-watt laser irradiation (4 TW, 42 fs at 780 nm) on a solid copper target has been studied in a range of the laser-power density between 3×1016 and 2×1017 W/cm2. Short-pulsed x rays are generated within 6.4 ps and include Cu Kα and Kβ line emissions and a continuum between 3 and 6 keV. The maximum intensity of Cu Kα radiation has been estimated to be 6.5×1010 photons (4π sr pulse)−1. The mechanism of hard x-ray generation has been discussed.
In a bulk solid, optical control of atomic motion provides a better understanding of its physical properties and functionalities. Such studies would benefit from active control and visualization of atomic motions in arbitrary directions, yet, so far, mostly only one-dimensional control has been shown. Here we demonstrate a novel method to optically control and visualize two-dimensional atomic motions in a bulk solid. We use a femtosecond laser pulse to coherently superpose two orthogonal atomic motions in crystalline bismuth. The relative amplitudes of those two motions are manipulated by modulating the intensity profile of the laser pulse, and these controlled motions are quantitatively visualized by density functional theory calculations. Our control-visualization scheme is based on the simple, robust and universal concept that in any physical system, two-dimensional particle motion is decomposed into two orthogonal one-dimensional motions, and thus it is applicable to a variety of condensed matter systems.