The behavior of single drops of isotropic hydroxypropylcellulose solutions immersed in a polydimethylsiloxane matrix subjected to a constant shear rate was investigated using a rheo-optical technique. Our main results concern the nonstationary deformation and breakup mechanisms of drops characterized by large capillary numbers. The deformation of threads follows a pseudoaffine deformation for Ca/Cacrit larger than 2.5 and above a certain strain. The end pinching mechanism occurs at a specific scaled strain, which includes the initial drop size and the applied shear rate. Capillary instabilities develop when the thread diameter reaches a critical value, dr, inversely proportional to the applied shear rate and independent of the initial drop diameter. The time necessary for the total rupture of a thread depends on the initial drop diameter, the applied shear rate, and the critical thread diameter dr. The droplet size resulting from the final rupture of a thread is found to be half that of the critical size, below which a drop deforms into a stable ellipsoid.
1 November 2012 in International Polymer Processing
This study looks at the influence of extrusion parameters such as screw speed, feed rate and barrel temperature on the nanocomposite structure (size of agglomerates, level of intercalation and exfoliation) and its consequences on final mechanical properties. Nanocomposites of polypropylene, maleated polypropylene and organomodified montmorillonite, with respective mass fractions of 85/10/5, were prepared in a co-rotating twin-screw extruder using a masterbatch dilution method. The nanocomposites structure was quantified by scanning and transmission electron microscopy, X-ray diffraction and dynamic rheometry. Relationships between the microstructure at different levels (size and number of agglomerates, interlayer distance, melt yield stress to quantify the exfoliation level) and the processing conditions were established, revealing that specific mechanical energy received during extrusion was the key parameter controlling this microstructure. Mechanical properties in uniaxial tension (apparent Young's modulus) were measured and related to the microstructural parameters resulting from extrusion conditions.