Due to the non-uniform tension and compression strength of concrete, carbon fiber can be added to concrete to improve its static tensile behavior and increase the tension–compression ratio. In view of the destructive consequences of impacts and explosions, it is necessary to study the dynamic responses of carbon fiber reinforced concrete (CFRC) structures. Therefore, the effects of the stress rates and carbon fiber contents on the dynamic tension behavior of CFRC were investigated in this paper. The dynamic splitting tests of concrete with the fiber contents of 0, 0.1, 0.2, and 0.3% were carried out by using a split Hopkinson pressure bar (SHPB) device with a diameter of 74 mm. We found that with the increase of fiber content, the static tensile strength of CFRC increases obviously, but the increased amplitude tends to decrease. The dynamic tensile strength and dynamic increase factor (DIF) both increase with the increase of stress rate, but the growth rate slows down, showing an obvious rate effect. The rate sensitivity of ordinary concrete is higher than CFRC. There are significant differences in the influence of carbon fiber on the dynamic and static strength of concrete. In the design of concrete mixing proportion, the content of carbon fiber should be appropriately selected to meet the requirements of dynamic and static mechanical properties.
Slate with inherently transverse isotropy is abundant in metamorphic rock, in buildings, and in geotechnical engineering worldwide; the tensile and shear fracture behavior of layered slate is vital to know for engineering applications. In this paper, the Brazilian and semi-circular bend (SCB) tests of layered slate were performed. The fracture characteristics of the slate were investigated by numerical simulations developed by the hybrid finite and cohesive element method (FCEM). Results showed that the measured experimental tensile strength, and mode I fracture toughness of layered slate all showed a typical V-type trend as the bedding angle increased from 0° to 90°, and with divider type. The developed empirical relationship between tensile fracture toughness and tensile strength KIC = 0.094σt + 0.036 fitted experimentally and strongly correlated. The mechanical response and fracture patterns predicted by FCEM agreed well with those of the laboratory experiments. Moreover, the shear fracture behavior and mode II fracture toughness of the layered slate were explored by systematic numerical simulations. Research results provide potential insights for further prediction and improvement of the complex fracture behavior of anisotropic rock masses for rock engineering.
Adding biochar to soil can improve the soil’s physical–chemical properties, microscopic pore structure, and bacterial habitat. This affects the soil’s strength characteristics and the oxidization of methane. Using a Humboldt pneumatic direct shear instrument, this study investigated the effect of the amount of biochar in the soil, the soil’s methane-oxidizing bacteria, aeration time, and carbon content on the strength characteristics of a biochar-amended clay. The results show that when the biochar content is low, the soil’s stress–strain curve shows a strain hardening state as the strain increases. When the biochar content is greater than 10%, the methane-oxidizing bacteria increase as the shear strain increases. The stress–strain curves of the biochar–clay mixture all showed a softened state. Under the same biochar content, the soil’s stress–strain curves show strain softening as the methane filling time increases. However, with an increase in the amount of biochar, cohesion gradually increased and the internal friction angle did not change significantly. A scanning electron microscope (SEM) image of the biochar–clay mixture with methane oxidizing bacteria revealed the influence of the evolution law of the samples’ micropore structure on the soil’s stress–strain curve and strength properties.