In order to clarify the role of different post-weld heat treatment processes in the manufacturing process, welding tests, post-weld heat treatment tests, and finite element analysis (FEA) are carried out for 12C1MoV steel pipes. The simulated temperature field and residual stress field agree well with the measured results, which indicates that the simulation method is available. The influence of post-weld heat treatment process parameters on residual stress reduction results is further analyzed. It is found that the post weld dehydrogenation treatment could not release residual stress obviously. However, the residual stress can be relieved by 65% with tempering treatment. The stress relief effect of “post weld dehydrogenation treatment + temper heat treatment” is same with that of “temper heat treatment”. The higher the temperature, the greater the residual stress reduction, when the peak temperature is at 650–750 °C, especially for the stress concentration area. The longer holding time has no obvious positive effect on the reduction of residual stress.

The stress corrosion cracking behavior of an Incoloy825/X65 bimetallic composite pipe welded joint in wet hydrogen sulfide (H₂S) environment was investigated by means of the creviced bent beam (CBB) test in this study. The microstructure, element distribution and crack propagation behavior of the welded joint were analyzed by optical microscope (OM), scanning electron microscope (SEM), electron dispersive spectroscopy (EDS) and electron backscatter diffraction (EBSD). The results showed that two types of cracks were observed in the Incoloy825/X65 bimetallic composite pipe welded joint in wet H₂S environment, they initiated from the notch and the intersection of the three zones (cladding Incoloy825, base X65 and weld), respectively, and propagated along the fusion boundary(FB) and the Type-II-like grain boundary. The mechanisms of the two types of cracks are due to the combination of anodic dissolution, stress and hydrogen. Near the FB, there are high angle grain boundaries, Type-I, Type-II and the Type-II-like grain boundaries, which have high SCC sensitivity. The element distribution in the intersection of the three zones and the crack tip is complex, with element diffusion, Cr loss and large residual strain. All these provide the conditions for cracks initiation and propagation.

Low stress interrupted creep test, as an interim compromise, can provide essential data for creep deformation design. However, there are no clear guidelines on the characterization of the terminating time for interrupted low-stress creep test. To obtain a suitable terminating time in terms of economy and effectiveness, long-term creep strain data of 9%Cr steels are collected from literatures and their creep deformation characterization is analyzed. First, the variations of normalized time and strain of each creep stage with the stress level are discussed. Then, the effect of the terminating time on final fitted results of Norton–Bailey equation is estimated. Third, the relationship between demarcation points at different creep stages and minimum/steady-state creep rate is analyzed. The results indicate that when the creep rupture life is considered as an important factor for creep design, the tertiary creep stage is of greatest significance due to the largest life fraction and creep strain fraction at low stress level. However, the primary and secondary creep stages are of great significance for design due to their larger contribution to 1% limited creep strain. And the long-term secondary creep data could be extrapolated by combining the primary creep strain data obtained from interrupted creep tests with the time to onset of tertiary creep derived from a similar Monkman–Grant relationship.