Du Ho

Mr. Du Ho

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2017
Verified
Conference Paper
Closed access
DHDu Ho
Du Ho
JLJonas Linder
Jonas Linder
GHGustaf Hendeby
Gustaf Hendeby
MEMartin Enqvist
Martin Enqvist
In this paper, an approach to estimate the mass of a quadcopter using only inertial measurements and pilot commands is presented. For this purpose, a lateral dynamic model describing the relation between the roll rate and the lateral acceleration is formulated. Due to the quadcopter's inherent instability, a controller is used to stabilize the system and the data is collected in closed loop. Under the effect of feedback and disturbances, the inertial measurements used as input and output are correlated with the disturbances, which complicates the parameter estimation. The parameters of the model are estimated using several methods. The simulation and experimental results show that the instrumental-variable method has the best potential to estimate the mass of the quadcopter in this setup.

1 October 2017
Verified
Conference Paper
Closed access
DHDu Ho
Du Ho
JLJonas Linder
Jonas Linder
GHGustaf Hendeby
Gustaf Hendeby
MEMartin Enqvist
Martin Enqvist
In this work, we estimate a model of the vertical dynamics of a quadcopter and explain how this model can be used for mass estimation and diagnosis of system changes. First, a standard thrust model describing the relation between the calculated control signals of the rotors and the thrust that is commonly used in literature is estimated. The estimation results are compared to those using a refined thrust model and it turns out that the refined model gives a significant improvement. The combination of a nonlinear model and closed-loop data poses some challenges and it is shown that an instrumental variables approach can be used to obtain accurate estimates. Furthermore, we show that the refined model opens up for fault detection of the quadcopter. More specifically, this model can be used for mass estimation and also for diagnosis of other parameters that might vary between and during missions.


1 January 2015 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
APAnh Tuan Phan
Anh Tuan Phan
DHDuc Du Ho
Duc Du Ho
GHGilles Hermann
Gilles Hermann
Patrice WiraPatrice Wira
Patrice Wira
For power quality issues like reducing harmonic pollution, reactive power and load unbalance, the estimation of the fundamental frequency of a power lines in a fast and precise way is essential. This paper introduces a new state-space model to be used with an extended Kalman filter (EKF) for estimating the frequency of distorted power system signals in real-time. The proposed model takes into account all the characteristics of a general three-phase power system and mainly the unbalance. Therefore, the symmetrical components of the power system, i.e., their amplitude and phase angle values, can also be deduced at each iteration from the proposed state-space model. The effectiveness of the method has been evaluated. Results and comparisons of online frequency estimation and symmetrical components identification show the efficiency of the proposed method for disturbed and time-varying signals.

1 January 2020 in IFAC-PapersOnLine
Verified
Journal Article
Open access
DHDu Ho
Du Ho
GHGustaf Hendeby
Gustaf Hendeby
Martin EnqvistMartin Enqvist
Martin Enqvist
This paper addresses the problem of change detection for a quadcopter in the presence of wind disturbances. Different aspects of the quadcopter dynamics and various flight conditions have been investigated. First, the wind is modeled using the Dryden wind model as a sum of a low-frequent and a turbulent part. Since the closed-loop control can compensate for system changes and disturbances and the effect of the wind disturbance is significant, the residuals obtained from a standard simulation model can be misleading. Instead, a sensor-to-sensor submodel of the quadcopter is selected to detect a change in the payload using the Instrumental Variables (IV) cost function. It is shown that the mass variation can be detected using the IV cost function in different flight scenarios.