We demonstrate an 806 nm laser diode end-pumped continuous-wave (CW) and actively Q-switched (AQS) orthogonally-polarized dual-wavelength Nd:YLF laser operating at 1314 and 1321 nm. Benefitting from the small difference of the stimulated emission cross sections at 1314 and 1321 nm in Nd:YLF crystal, the power equalized emissions at both wavelengths were achieved by simply titling the output coupler. A maximum CW output power of 9.2 W was obtained with the incident pump power of 32.5 W, giving an optical-to-optical conversion efficiency of approximately 28% and a slope efficiency of approximately 33%. Furthermore, active Q-switching was realized by inserting a Brewster-cut acousto optic modulator. For an incident pump power of 30 W, this oscillator delivered an average power of 6.5 W at a pulse repetition frequency (PRF) of 20 kHz, and a pulse energy of 2.6 mJ with a peak power of approximately 72 kW at a PRF of 1 kHz.
We report a high average power actively -switched (AQS) orthogonal polarization dual-wavelength Nd:YLF laser at 1047 and 1053 nm. The gain-to-loss balance of dual wavelengths was realized via an uncoated quartz etalon. A maximum continuous wave (CW) output power of 14.2 W was obtained under the incident pump power of 41.7 W, corresponding to an optical-to-optical conversion efficiency of 34.1% and a slope efficiency of 38.3%. Active -switching was accomplished by inserting an acousto-optic modulator in the cavity. Under the incident pump power of 40 W, this setup delivered a maximum average output power of 10 W at the pulse repetition frequency (PRF) of 30 kHz and the largest pulse energy of 3.4 mJ at the PRF of 1 kHz, respectively. To the best of our knowledge, these are the highest average output powers for both CW and AQS orthogonally polarized dual-wavelength lasers based on laser crystals.
A single-longitudinal-mode crystalline Raman laser in the 1.7 µm wave band was reported for the first time, to the best of our knowledge. The Raman laser, which was intracavity-pumped by an actively -switched 1314 nm Nd:YLF laser, demonstrated the cascaded Stokes oscillation at 1715 nm. By inserting an etalon in the fundamental resonator, linewidth narrowing and power scaling of the second-Stokes laser were realized based on the spatial-hole-burning-free Raman gain. With an optimal pulse repetition frequency of 4 kHz, the maximum single-longitudinal-mode average output power of 1.8 W was acquired with the spectrum linewidth of . Further increasing the incident pump power, the second-Stokes laser transitioned to multimode regime, and the maximum average output power reached 2.7 W with the peak power as high as .
We demonstrate the first nanosecond pulsed single longitudinal mode (SLM) intracavity-pumped diamond Raman laser, to the best of our knowledge. The eye-safe coherent source at 1634 nm, which was converted from the actively Q-switched 1342 nm Nd:YVO4 laser, yielded 4.35 W of multimode average output power with a pulse duration of 6 ns and peak power of 29 kW. By exploiting the spatial hole burning free gain mechanism in the Raman media, stable SLM operation was observed at low output power (0.46 W) for the free-running case. Furthermore, by incorporating an etalon in the fundamental standing-wave cavity, the spectral linewidth of the fundamental field was suppressed substantially below the diamond Raman gain linewidth and slightly less than the free spectral range of the mm-scale Raman resonator. Thereby, a much higher SLM output power of 1.63 W was obtained with a pulse duration of ∼9 ns and a spectral linewidth of ∼77 MHz.
We demonstrated a deep-red laser source by intracavity frequency-doubled crystalline Raman laser for the first time, to the best of our knowledge. The actively -switched 1314 nm laser was first converted to the eye-safe Raman laser using a (KGW) crystal, which was subsequently frequency-doubled in a bismuth borate crystal. Benefiting from the KGW bi-axial properties, the deep-red laser source was able to lase separately at two different spectral lines at 730 and 745 nm. Under an optimal repetition rate of 4 kHz, the maximum average powers of 1.7 and 2.0 W were attained with good beam quality of . The corresponding pulse durations were determined to be 3.0 and 2.8 ns with the peak powers up to approximately 140 and 180 kW, respectively.
We report on a high average power and high repetition rate nanosecond pulsed eye-safe KGW Raman laser intracavity driven by an acousto-optic Q-switched 1342 nm two-crystal Nd:YVO4 laser. Taking advantages of the carefully selected two-composite-laser-crystal configuration, the thoroughly optimized gate-open time of acousto-optic modulator and the ingeniously designed U-shaped resonator, substantial power and efficiency enhancements as well as superior mode matching have been enabled. Under the injected pump power of 64.5 W, the average output powers of the first-Stokes fields at 1496 and 1527 nm can be up to 8.1 and 9.5 W with 25 kHz repetition rate and 3.2 µs gate-open time, respectively, corresponding to the optical power conversion efficiencies of 12.6% and 14.7%. Meantime, the resultant pulse widths are determined to be 4.6 and 6.3 ns with the peak powers of approximately 70 and 60 kW, respectively. The beam quality can be maintained with M2 < 1.5 across the entire output power range.