We studied the charging of inert surfaces (polytetrafluoroethylene, i.e., PTFE; graphite; graphene; and hydrophobic silica) using classical colloid chemistry approaches. Potentiometric titrations showed that these surfaces acquired less charge from proton-related reactions than oxide minerals. The data from batch-type titrations for PTFE powder did not show an effect of ionic strength, which was also in contrast with results for classical colloids. In agreement with classical colloids, the electrokinetic results for inert surfaces showed the typical salt level dependence. In some cases, the point of zero net proton charge as determined from mass and tentatively from acid–base titration differed from isoelectric points, which has also been previously observed, for example by Chibowski and co-workers for ice electrolyte interfaces. Finally, we found no evidence for surface contaminations of our PTFE particles before and after immersion in aqueous solutions. Only in the presence of NaCl-containing solutions did cryo-XPS detect oxygen from water. We believe that our low isoelectric points for PTFE were not due to impurities. Moreover, the measured buffering at pH 3 could not be explained by sub-micromolar concentrations of contaminants. The most comprehensive explanation for the various sets of data is that hydroxide ion accumulation occurred at the interfaces between inert surfaces and aqueous solutions.
Molybdenum(VI) catalysts were obtained from methanol or acetonitrile by the reaction of [MoO2(C5H7O2)2] and isonicotinoyl- or nicotinoyl-based aroylhydrazones. Reactions in methanol resulted in the formation of the mononuclear complexes [MoO2(L1–4)(MeOH)] (1a–4a), while the ones in acetonitrile provided polynuclear complexes [MoO2(L1–4)]n (1–4). Crystals of polynuclear compound, [MoO2(L3)]n∙H2O (3∙H2O), suitable for X-ray diffraction analysis were obtained by the solvothermal procedure at 110 °C. Complexes were characterized by infrared spectroscopy (IR-ATR), nuclear magnetic resonance (NMR), elemental analysis (EA), and thermogravimetric analysis (TGA). The prepared catalysts were tested in alcohol oxidation reactions. Carveol, cyclohexanol, and butan-2-ol were investigated substrates. Because the alcohol oxidations are very challenging due to various possible pathways, the idea was to test different oxidants, H2O2, TBHP in water and decane, to optimize the researched catalytic system.