Owing to an increased demand for fuel and the depletion of fossil fuels, an alternative source such as algae is currently being exploited for biofuel production. One such potential microalgal candidate for biofuel production is Scenedesmus abundans. The aim of this study was to optimize the growth and lipid content of Scenedesmus abundans in a batch culture system in order to extend its applicability to the commercial production of biodiesel. Optimization of growth parameters such as culture time, concentration of inoculum, and concentration of sodium bicarbonate was performed by Central Composite Design-Response Surface Methodology (CCD-RSM) to maximize production of biomass as well as biofuel yield. The results obtained using CCD-RSM indicate that 30 days, 10% of inoculum and 8 g L−1 of sodium bicarbonate are optimum working parameters to achieve a tentative maximum biomass yield of 0.0391 g per L per day and a maximum lipid content of 26.28% dcw. It was observed that the model prediction values satisfactorily matched the investigated values, within ±2%, for both growth rate and lipid content. Moreover, the individual and synergistic effects of the operational parameters on growth rate and lipid content were analyzed. The obtained experimental data were fitted to Lineweaver–Burk, Langmuir Hanes, Eadie and Eddie Hofstee plots. Among these models, the Langmuir Hanes method was found to provide the best fit, with a coefficient of regression of 0.9888. Consequently, the results of the study indicate that Scenedesmus abundans would be an apt natural source for biodiesel production.
20 July 2022 in Biomass Conversion and Biorefinery
Heterogeneous acid catalyst of nano size was prepared by the method of sulfonation of C. pentandra stalks and used to convert C. pentandra seed oil to biodiesel. The structure of the catalyst was characterized and physicochemical properties of extracted oil as well as effects of different preparation conditions on biodiesel yield were investigated. A scanning electron microscopy (SEM) photograph showed that the catalyst had a porous structure which enhanced the catalytic ability. From the Brunauer–Emmet–Teller (BET) analysis, the catalyst specific surface area was 714 m2 g−1 and average pore size was 4.8 nm. The optimal triglyceride conversion of 99% was attained at a reaction temperature of 220 °C, methanol to oil ratio of 18 : 1 M and catalyst concentration of 1.5 wt%. Reusability of the catalyst was studied which demonstrates drastic decrease in energy expenditure and waste generation in the production of biodiesel. Biodiesel viscosity was higher whereas other properties were found to be similar to those of commercial diesel oil and compared with ASTM D6751 and EN standards.
4 January 2013 in Journal of Chemical & Engineering Data