Photovoltaic panels (PV) are one of the most popular technological solutions used to produce green renewable energy. They are known as green technology, but by analyzing a life cycle of a common panel, we can find out that production of these panels is strictly associated with generation of a large waste stream. PV modules are constantly modified and, therefore, it is required to consider the impact of the applied materials on the environment during the whole lifecycle of the product. The most important aspect of the assessment of a life cycle of a photovoltaic module in the phase of decommissioning is material recycling. The process of material recycling is very difficult, due to the lamination used in the currently exploited technology. This paper presents the results of pyrolysis for a sample of a silicon module. The results of the presented research show a weight loss of 48.16 in case of the tested samples. This paper presents the outcome of a quantitative analysis of the content of polycyclic aromatic for liquid and concentrations of Br, Cl and F for a gaseous fraction of pyrolysis products. The goal of the research presented in the paper was to find the optimal parameters for thermal separation, as well as the influence of the energy consumption and materials separation efficiency on the final thermal efficiency of the process.

One of the greatest challenges humankind currently faces is global warming, mainly caused by greenhouse gas emissions. Here we have attempted to show how thermal conversion products, specifically from the pyrolysis of biomass wastes such as sewage sludge, can be used effectively and equivalently to sequester CO₂ in brownfield and degraded areas. Scenarios were devised that showed the significant potential for CO₂ sequestration in the form of biochar from sewage sludge deposited on degraded and brownfield areas. With the current amount of sludge production, such sludge could even be used in its entirety as a raw material in pyrolysis processes, where, in addition to the biochar, the heat necessary for drying the sludge could be generated and high-energy gas and liquid fractions could be obtained, which could be used to produce alternative fuels. It is therefore important to consider both the potential for CO₂ sequestration on degraded and brownfield sites and the potential for sludge disposal in Europe as viable options for reducing greenhouse gas emissions and promoting sustainable waste management practices.

The main source of mercury (Hg) anthropogenic emissions is the combustion of hard and lignite coal in power plants. Reduction of Hg emissions from coal-based power production systems involves Hg removal from the fuel before combustion/gasification by thermal treatment (i.e., low-temperature pyrolysis). Herein, we present the results of laboratory and bench-scale studies on Hg removal from coal via thermal fuel treatment. The influence of the process temperature and coal residence time in the reaction zone on Hg removal efficiency and fuel parameters is studied. The properties of the process products are analyzed as follows: proximate and ultimate analysis for solids as well as H_2, N_2, CO, CO_2, CH₄, organic compounds C2–C5, density, and HHV for gaseous. The results show a substantial reduction of Hg in the fuel using a low-temperature pyrolysis process. At moderate pyrolysis temperature provided Hg removal efficiencies of up to 50% for hard coal and over 90% for lignite, with a moderate decrease in the chemical enthalpy of the fuel.

Protection of the natural environment is one of the most significant global challenges for the international community. World problems arising as a result of the incineration of fossil fuels, excessive CO₂ emissions, erosion and soil degradation, as well as air pollution with the accelerating greenhouse effect and changes to the climate condition, make it necessary to take action at many levels. Environmental protection and the protection of natural resources need to follow the principles of sustainable development. Looking for alternative energy sources is appropriate but not sufficient and should be conducted in various areas since natural environmental changes are accelerating with many consequences. Therefore, there is demand for implementation of applications aimed at protecting air, and soil, preventing waste formation and combating the greenhouse effect. Therefore, the multi-directional use of various biocarbon substances for activities related to renewable energy, land reclamation, and carbon dioxide capture from the atmosphere is a promising and significant direction. This paper presents multidirectional analysis related to the use of biocarbon obtained from biomass and MSW waste.