Airborne multichannel high-resolution radar (HRR)-ground moving target indication (GMTI) is of great significance to wide-area surveillance, traffic monitoring and target recognition. The Aerospace Information Research Institute, Chinese Academy of Sciences, produced an advanced airborne digital array radar with high resolution and conducted an experiment with slow and weak cooperative moving targets in 2021. In this paper, an overall processing framework for target detection, parameter estimation and target tracking using this system is introduced. For HRR detection, the echo energy of targets is spread into multiple range units, so-called range-spread targets; thus, using detectors designed for point-like targets will severely degrade the detection performance, especially for slow and weak targets. To address the adaptive detection of such range-spread targets embedded in Gaussian clutter with an unknown covariance matrix, a novel two-step generalized space-time adaptive processing (GSTAP) algorithm is proposed, which offers an enhanced clutter suppression capability compared with natural competitors. Moreover, a tracking method is implemented in the range-Doppler domain to avoid track loss caused by azimuth relocation error and reject discrete false alarms. Both simulation and experimental results are presented to demonstrate the effectiveness of the proposed method and provide a paradigm for further research.

Synthetic aperture radar (SAR) installed on unmanned aerial vehicles (UAVs) has drawn increasing attention in the area of remote sensing due to its high spatial resolution and low energy consumption. However, due to the sensitivity toward atmospheric turbulences, strong motion errors can defocus the image in both azimuth and range directions. In this article, based on symmetric triangular linear frequency-modulation continuous microwave (STLFMCW) signals, a novel motion error estimation method is proposed. The core concept is to eliminate the effect of residual range cell migration (RCM) and investigate the motion parameters from azimuth phase history by range-frequency-domain interferometry between the up-ramp and down-ramp chirp sections. With preknowledge of the structural characteristics of the differential signal, we first obtain the high-order component, then estimate the quadratic term with an azimuth profile width minimization (APWM) algorithm on the basis of bisection search, and subsequently remove the linear part through phase gradient matching and joining. Consequently, the desired motion errors can be achieved purely based on raw data. Simulations demonstrate that our proposed algorithm can achieve high accuracy with or without standard prominent point targets. Experimental results on a W-band UAV SAR system in strip-map mode indicate that this approach also outperforms other existing postprocessing autofocus methods.

In this paper, we propose an unmanned aerial vehicle (UAV) enabled multi-stage integrated sensing and communications (ISAC) system, where a multi-antenna equipped UAV performs location sensing for a target whose location is initially unknown, while serves the communication users simultaneously, with the aid of an existing receive access point (RAP). By fusing the measurement results of the UAV and RAP, the location of the target is estimated. To improve the location sensing accuracy, we propose a multi-stage location sensing scheme. Specifically, in the first stage, in the absence of prior knowledge about the target’s location, the UAV fixes at the initial location and adjusts the beamformer to perform wide beam sensing to probe the target. In the following stages, with the previous coarse estimation result of the target’s location, the UAV performs narrow beam sensing by jointly adjusting the placement and also transmit beamformer. Besides, the quality of service requirements of the users are guaranteed in all stages. Accordingly, optimization problems are formulated for the first and following stages, respectively. By involving the semidefinite relaxation technique and then solving a quadratic semidefinite programming problem, the solution in the first stage is obtained. In the following stages, we jointly apply the alternating optimization, successive convex approximation, trust region, and also Dinkelbach’s methods to address the intricate coupling between the UAV placement and beamformer. Finally, numerical results demonstrate the effectiveness of the proposed algorithms.

The post-Doppler adaptive matched filter (PD-AMF) with constant false alarm rate (CFAR) property was developed for adaptive detection of moving targets, which is a standardized version of the post-Doppler space–time adaptive processing (PD-STAP) in practical applications. However, its detection performance is severely constrained by the training data, especially in a dense signal environment. Improper training data and contamination of moving target signals remarkably degrade the performance of disturbance suppression and result in target cancellation by self-whitening. To address these issues, a novel post-Doppler parametric adaptive matched filter (PD-PAMF) detector is proposed in the range-Doppler domain. Specifically, the detector is introduced via the post-Doppler matched filter (PD-MF) and the lower-diagonal-upper (LDU) decomposition of the disturbance covariance matrix, and the disturbance signals of the spatial sequence are modelled as an auto-regressive (AR) process for filtering. The purpose of detecting ground moving targets as well as for estimating their geographical positions and line-of-sight velocities is achieved when the disturbance is suppressed. The PD-PAMF is able to reach higher performances by using only a smaller training data size. More importantly, it is tolerant to moving target signals contained in the training data. The PD-PAMF also has a lower computational complexity. Numerical results are presented to demonstrate the effectiveness of the proposed detector.

This letter focuses on the detection of subtle human activity, from multipass airborne interferometric synthetic aperture radar (InSAR) images, of such activities causing absolute decorrelation between two acquisitions. These activities can be vehicle track, footprint, grazing, and human construction. The millimetric sensitivity of the interferometric phase makes it valuable for detecting such activities. It can bring a large value to civil and military applications. However, there are always high false alarms in the conventional detection method. To solve this problem, a human activity detection method based on the coherence matrix is approached in this letter. In the final part of this letter, a preliminary validation of the method is provided by processing actual multipass airborne InSAR data stacks acquired by the Aerospace Information Research Institute, Chinese Academy of Sciences. It is noted that the proposed method reaches reliable results in comparison with the ground truth.

This paper focuses on the study of a multi-frequency interferometric coherence characteristics analysis of typical objects for coherent change detection. Coherent change detection utilizes the phase difference between two or more SAR images to detect potential changes in the scene. It makes a difference in civilian and military applications. However, the relationship between the coherence of typical objects and SAR frequency has not been fully studied, which restricts the quality of the detection results. To address this problem, this paper conducts research on the relationship between the coherence of typical objects and SAR frequency, and the coherence characteristics are obtained through statistical analysis. In order to illustrate the relationship more clearly, the actual experimental data obtained by the DVD-InSAR system developed by the Aerospace Information Research Institute, Chinese Academy of Sciences, are utilized. The experimental results show that the coherence characteristics of typical objects are different, and this finding can provide strong support for developing change-detection applications.