We prepared three kinds of Ni based alloy cladding coatings on 316L stainless steel at different power levels. The microstructure of the cladding layer was observed and analyzed by XRD, metallographic microscope, and SEM. The hardness of the cladding layer was measured, and the wear resistance of it was tested by a friction instrument. The results show that the effect of laser cladding is good, and it has good metallurgical bonding with the substrate. Different microstructures such as dendritic and equiaxed grains can be observed in the cladding layer. With the increase in laser power, more equiaxed and columnar dendrites can be observed. The phase composition of the cladding layer is mainly composed of γ–Ni solid solution and some intermetallic compounds such as Ni₃B, Cr₅B_3, and Ni₁₇Si₃. The results of EDS show that there are some differences in the distribution of C and Si between dendrites. The hardness of the cladding layer is about 600 HV_0.2, which is about three times of the substrate (~200 HV_0.2). Through the analysis of the wear morphology, the substrate wear is serious, there are serious shedding, mainly adhesive wear, and abrasive wear. However, the wear of the cladding layer is slight, which is abrasive wear, and there are some grooves on the surface.

In this study, single-layer and three-layer nickel-based coatings were fabricated on 316L SS by laser additive manufacturing. The phase characterization, microstructure observation, and microhardness analysis of the coatings were carried out by X-ray diffraction (XRD), scanning electron microscope (SEM), and microhardness tester. And the wear resistance of the coatings was analyzed through dry sliding friction and wear test. The results show that the cross-section microstructure of the three-layer nickel-based coating is different from that of the single-layer one under the influence of heat accumulation; the dendrite structure in the central region of the former is equiaxial dendrite, while that of the latter still remains large columnar dendrites. The existence of solid solution phase γ-(Fe, Ni) and hard phases of Ni₁₇Si₃, Cr₅B₃, Ni₃B in the coating significantly improve the wear resistance of the coating, and the microhardness is nearly 2.5 times higher than that of the substrate. However, the average microhardness of multilayer cladding coating is about 48 HV_0.2 higher than that of the single-layer cladding coating. In addition, the fine surface structure of the three-layer nickel-based coating improves the wear resistance of the coating, making this coating with the best wear resistance.

To prepare wrought magnesium alloys with excellent plastic deformation properties, Mg-3Sn-2Al-1Zn-0.6Nd alloys were prepared. A hot compression test of Mg-3Sn-2Al-1Zn-0.6Nd alloy was carried out on a thermo-mechanical simulator. The hot deformation behavior of the alloys was studied, and the constitutive equations and the processing map at the strain of 0.8 were established. The processing map exhibited the stable domain (temperature range of 320–350 °C and strain rate range of 0.001–0.04 s⁻¹) with the high power dissipation efficiency (>30%). A large number of fine dynamic recrystallization (DRX) grains and deformed twinning existed in the alloy after the hot deformation. The dominant texture of the Mg-3Sn-2Al-1Zn-0.6Nd alloy is //CD texture after the hot deformation. The continuous dynamic recrystallization (CDRX) and discontinuous dynamic recrystallization (DDRX) were the dominant recrystallization mechanisms, and {10$\overline{1}$2} extension twinning also occurred in the alloy during the hot deformation.