Recent studies have proposed usage of biochar as a substrate amendment in green infrastructure, such as green roofs and bio-filtration units. However, understanding of the variation in physio-chemical properties of biochar due to the production process and feedstock is still lacking. The present study investigated the effects of pyrolysis temperature and feedstocks on the hygroscopic water content and physio-chemical properties of biochar. Biochars were produced from three feedstock types, invasive vegetation (i.e., water hyacinth), non-invasive vegetation (i.e., wood) and one animal waste (i.e., chicken manure). Biochar was produced at two different pyrolysis temperatures (i.e., 300 °C and 600 °C). Scanning electron microscopy + energy dispersive spectrometry (SEM + EDS), Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), and Brunauer-Emmett-Teller (BET) were performed on all samples to analyze the surface morphology, pore size, element content, functional groups, and chemical bonds. Relative humidity was adjusted to reflect the biochar’s hygroscopic property by measuring the maximum moisture content at the sample equilibrium state. The characterization reveals that the lowest carbon content (42.78%) was found at 300 °C for water hyacinth biochar (WHB). The highest carbon content (92.14%) was found at 600 °C for wood biochar (WB). As the pyrolysis temperature increased, the mean pore volume (from 0.03 to 0.18 cm³/g) and diameter (from 8.40 to 10.33 nm) of the WHB increased. However, the pore diameter of chicken manure (CB) decreased (from 9.23 nm to 7.53 nm) under an increase in pyrolysis temperature. For a given pyrolysis temperature, the hygroscopicity of WHB was highest among all biochars. With an increase in pyrolysis temperature, the hygroscopicity of biochars changed differently. The hygroscopicity of WHB decreased from 82.41% to 44.33% with an increase of pyrolysis temperature. However, the hygroscopicity of CMB and WB remained unchanged. This study suggests that production process of biochars need to be considered for appropriate selection as substrate material in green infrastructure. Further, it promotes the establishment of commercial production of biochar for usage in green infrastructure.

Biofiltration systems are a promising retrofit option for site-constrained urban areas due to the vertical arrangement of treatment stages that leads to a relatively compact footprint. Existing knowledge about the influence of their design and configuration on hydrological, stormwater pollutant removal and long-term performance is limited and this has been identified as a barrier to their widespread uptake. Long-term simulations of lined and unlined biofiltration systems in four contrasting UK climatic regimes were used to assess the influence of climate, ponding depth, biofilter to drainage area ratio and infiltration rate on hydrological performance. The results showed that local differences in climate have a significant impact on performance and that infiltration rates as low as 0·36 mm/h are not suitable for locations in the UK with high rainfall unless the biofilter to drainage area ratio is greater than 10%. However, with higher infiltration rates (72 mm/h) a biofilter occupying only 3% of the impermeable catchment area would be capable of infiltrating 97% of annual rainfall in central England. Preliminary results of adsorption and column tests to assess the effectiveness of media amendments, specifically zeolite and granular activated carbon, for dissolved copper and phosphate removal are presented in this paper.