Sets of silica gels: aerogels, xerogels and sintered aerogels, have been studied in the objective to understand the mechanical behavior of these highly porous solids. The mechanical behaviour of gels is described in terms of elastic and brittle materials, like glasses or ceramics. The magnitude of the elastic and rupture modulus is several orders of magnitude lower compared to dense glass. The mechanical behaviours (elastic and brittle) are related to the same kinds of gel characteristics: pore volume, silanol content and pore size. Elastic modulus depends strongly on the volume fraction of pores and on the condensation reaction between silanols. Concerning the brittleness features: rupture modulus and toughness, it is shown that pores size plays an important role. Pores can be considered as flaws in the terms of fracture mechanics and the flaw size is related to the pore size. Weibull’s theory is used to show the statistical nature of flaw. Moreover, stress corrosion behaviour is studied as a function of environmental conditions (water and alcoholic atmosphere) and temperature.
Silica aerogels are known to be materials with exceptional characteristics, such as ultra-low density, high surface area, high porosity, high adsorption, and low-thermal conductivity. In addition, these unique properties are mainly related to their specific processing. Depending on the aerogel synthesis procedure, the aerogels texture can be tailored with meso and/or macroporosity. Fractal geometry has been observed and used to describe silica aerogels at nanoscales in certain conditions. In this review paper, we describe the fractal structure of silica aerogels that can develop depending on the synthesis conditions. X-ray and neutron scattering measurements allow to show that silica aerogels can exhibit a fractal structure over one or even more than two orders of magnitude in length. The fractal dimension does not depend directly on the material density but can vary with the synthesis conditions. It ranges typically between 1.6 and 2.4. The effect of the introduction of silica particles or of further thermal treatment or compression of the silica aerogels on their microstructure and their fractal characteristics is also resumed.
The integration of optical circuits with microfluidic lab-on-chip (LoC) devices has resulted in a new era of potential in terms of both sample manipulation and detection at the micro-scale. On-chip optical components increase both control and analytical capabilities while reducing reliance on expensive laboratory photonic equipment that has limited microfluidic development. Notably, in-situ LoC devices for bio-chemical applications such as diagnostics and environmental monitoring could provide great value as low-cost, portable and highly sensitive systems. Multiple challenges remain however due to the complexity involved with combining photonics with micro-fabricated systems. Here, we aim to highlight the progress that optical on-chip systems have made in recent years regarding the main LoC applications: (1) sample manipulation and (2) detection. At the same time, we aim to address the constraints that limit industrial scaling of this technology. Through evaluating various fabrication methods, material choices and novel approaches of optic and fluidic integration, we aim to illustrate how optic-enabled LoC approaches are providing new possibilities for both sample analysis and manipulation.
18 October 2025 in European Journal of Applied Physiology
A chemically amplified hybrid photoresist based on hydrolysed MAPTMS-co-TBMA enables positive-tone photolithography in aqueous TMAH, producing thick (≈40 µm ± 7 µm) micro structured films with strong adhesion.