Environmental context: Although organoarsenic compounds occur in marine organisms at high concentrations, the origin and role of these compounds is unknown. Arsenic-containing lipids (arsenolipids) are newly discovered compounds in fish. We identify a range of arsenolipids in algae and propose that algae are the origin of these unusual arsenic compounds in marine ecosystems. Fourteen arsenolipids, including 11 new compounds, were identified and quantified in two species of brown algae, Wakame (Undaria pinnatifida) and Hijiki (Hizikia fusiformis), by high resolution mass spectrometry, high performance liquid chromatography–mass spectrometry and gas chromatography–mass spectrometry. Both algal species contained arsenosugar-phospholipids as the major type of arsenolipid, and arsenic-hydrocarbons were also significant components, particularly in Hijiki. The origin of the various arsenolipids, and the possible significance of their relative quantities, is briefly discussed.

Arsenic and heavy metal (specifically Cd, Cr, Cu, Ni, Pb, and Zn) uptake, translocation, and accumulation in ten native plant species spontaneously growing in soils polluted by mining activities were studied, with a focus on future phytoremediation work in polluted soils. Plant and soil samples were collected in the vicinity of the Mónica mine (NW Madrid, Spain). Soil analysis showed the ability of native plants for growing in soils with high concentration levels of Cd, Cu, Pb, Zn, and especially As. From these elements, the highest percentage of extractable elements was found for Cd and the lowest for Pb. A highly significant correlation was observed between total and extractable element concentrations in soils, except for Cu, indicating that total concentration is the most relevant factor for element mobility in these soils. Extractable elements in soils were better correlated with concentrations in plants than total elements in soils; thus, extraction methods applied are suitable to estimate the element phytoavailable fraction in soils, which depends on the plant species and not only on the element mobility in soils. High element concentrations were found in the aboveground parts of Corrigiola telephiifolia (As and Pb), Jasione montana (Cd and Zn), and Digitalis thapsi (As, Cd, Cu, Pb and Zn). However, considering the translocation and accumulation factors, together with the concentration levels found in roots and aboveground parts, only C. telephiifolia could be considered a Pb accumulator and an As hyperaccumulator plant, which could be used for future phytoremediation work in soils polluted with As.

Twelve commercially available edible marine algae from France, Japan and Spain and the certified reference material (CRM) NIES No. 9 Sargassum fulvellum were analyzed for total arsenic and arsenic species. Total arsenic concentrations were determined by inductively coupled plasma atomic emission spectrometry (ICP-AES) after microwave digestion and ranged from 23 to 126 μg g(-1). Arsenic species in alga samples were extracted with deionized water by microwave-assisted extraction and showed extraction efficiencies from 49 to 98%, in terms of total arsenic. The presence of eleven arsenic species was studied by high performance liquid chromatography-ultraviolet photo-oxidation-hydride generation atomic-fluorescence spectrometry (HPLC-(UV)-HG-AFS) developed methods, using both anion and cation exchange chromatography. Glycerol and phosphate sugars were found in all alga samples analyzed, at concentrations between 0.11 and 22 μg g(-1), whereas sulfonate and sulfate sugars were only detected in three of them (0.6-7.2 μg g(-1)). Regarding arsenic toxic species, low concentration levels of dimethylarsinic acid (DMA) (<0.9 μg g(-1)) and generally high arsenate (As(V)) concentrations (up to 77 μg g(-1)) were found in most of the algae studied. The results obtained are of interest to highlight the need to perform speciation analysis and to introduce appropriate legislation to limit toxic arsenic species content in these food products.

Titania nanoparticles are intensely studied for photodegradation applications. Control of nanoscale morphology and microstructural properties of these materials is critical for photocatalytic performance. Uniform anatase-type TiO₂ nanoparticles were prepared by the sol-gel process using titanium isopropoxide as precursor. Controlled annealing up to 400 °C established crystallization and particle size ranging between 20 and 30 nm. Detailed thermal examination reveals that anatase phase transformation into rutile is affected by the annealing temperature and by the initial particle size. The anatase to rutile phase transformation occurs in the nanoparticles at 550 °C. The Total Reflection X-ray Fluorescence (TXRF) study of the anatase nanoparticles shows a shift towards higher energy in the Ka Ti line of 10 eV, related to structural defects. These features were discussed in the photocatalytic behavior of several cement-based materials modified with the so-prepared anatase nanoparticles. The photocatalytic activity of the anatase-type TiO₂/cement mortar system is evaluated from the degradation of Methylene Blue (MB) under UV irradiation, monitored through the absorbance at 665 nm. The results show that the photocatalytic composites exhibit up to 76.6% degradation efficiency. Mechanical testing of the nano-TiO₂ modified cementitious composites evinces a moderate reinforcement of the strength properties at long ages.

In order to achieve reliable information on speciation analysis, it is necessary to assess previously the species stability in the sample to analyse. Furthermore, in those cases where the sample treatment for species extraction is time-consuming, an assessment of the species integrity in the extracts is of paramount importance. Thus, the present paper reports total arsenic and arsenic species stability in alga samples (Sargassum fulvellum and Hizikia fusiformis), as well as in their aqueous extracts, which were stored in amber glass and polystyrene containers at different temperatures. Total arsenic determination was carried out by inductively coupled plasma atomic emission spectroscopy (ICP-AES), after sample acid digestion in a microwave oven, while arsenic speciation was conducted by anion exchange high performance liquid chromatography on-line coupled to ICP-AES, with and without sample introduction by hydride generation (HPLC-ICP-AES and HPLC-HG-ICP-AES), after aqueous microwave-assisted extraction. The results obtained for solid alga samples showed that total arsenic (for Hijiki alga) and arsenic species present (As(V) for Hijiki and NIES No. 9 Sargasso) are stable for at least 12 months when samples are stored in polystyrene containers at +20 degrees C. On the other hand, a different behaviour was observed in the stability of total arsenic and As(V) species in aqueous extracts for both samples, being the best storage conditions for Sargasso extracts a temperature of -18 degrees C and polystyrene containers, under which they are stable for at least 15 days, while Hijiki extracts must be stored in polystyrene containers at +4 degrees C in order to ensure the stability for 10 days.