Florin Adelin Pop Piglesan

Dr. Florin Adelin Pop Piglesan

Technical University Cluj Napoca
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 January 2021 in Energies
Verified
Journal Article
Open access
PDF file
Florin Adelin Pop PiglesanFlorin Adelin Pop Piglesan
Florin Adelin Pop Piglesan
APAdrian-Cornel Pop
Adrian-Cornel Pop
CMClaudia Steluța Marțiș
Claudia Steluța Marțiș
In this paper a side-by-side comparison between synchronous reluctance machines (SynRMs) with concentrated and distributed windings is performed. The characteristics, parameters, and the installation space of a permanent magnet synchronous machine (PMSM) with concentrated windings used in a 13 V automotive cooling fan system (CFMs) are used as requirements and specifications. For that, eight SynRMs with different stator and rotor topologies are investigated and optimized by means of FE-based electromagnetic optimization. Knowing the challenges associated with the development of mechanically stable SynRM rotor structures, for two selected cross-sections in view of being prototyped, designs checks are performed to ensure robust operation at up to two times the required operating speed. The simulated results were verified by means of measurements performed using two different types of loading systems, i.e., with the real ventilator and using a DC machine as a load. Based on this, the relative differences between all three motor technologies in terms of important quantities (e.g., torque-speed characteristic, torque ripple, efficiency, power factor and ultimately the size) are highlighted.

12 October 2022 in Coatings
Verified
Journal Article
Open access
PDF file
BNBogdan Neamtu
Bogdan Neamtu
FPFlorin Popa
Florin Popa
EWEcaterina Ware
Ecaterina Ware
TMTraian Florin Marinca
Traian Florin Marinca
MGMihai Gabor
Mihai Gabor
Mircea NasuiMircea Nasui
Mircea Nasui
This paper presents findings on the influence of hydrothermal deposition processing parameters (precursor concentration and deposition duration) on the characteristics of ZnO layers deposited on the surface of amorphous Fe-based fibres. The characteristics of the coated fibres, especially the deposited layer, were investigated from structural, morphological, chemical, thermal and magnetic points of view. It was found that the use of a zinc acetate-based solution of 0.05 M concentration and a deposition duration of 24 h leads to a continuous, thin and adherent layer of ZnO on the surface of the fibres. The thickness of the ZnO layer is 450–500 nm, as shown by TEM-EDX investigations. The ZnO coated fibres were used to prepare fibre-based soft magnetic composites via a cold sintering process. The composites obtained are the first reported soft magnetic composites based on amorphous fibres. The coercive field of the cold sintered composites is 3.5 to 8.6 times lower, and the maximum relative permeability is 2.4 times larger, than the best coercive field and the maximum relative permeability reported until now for a crystalline fibre-based soft magnetic composite. The initial relative permeability of cold sintered composites is constant up to the frequency of 1000 Hz.