With the penetration of renewable energy sources based distributed generation (RES-DG) in the distribution network (DN), the operating time of protection relays becomes a major concern to avoid the mis-coordination and nuisance tripping of RES-DG. It is due to the bidirectional flow of current, variance in the fault current level, i.e. high fault current in case of Squirrel cage induction generator (SCIG) based RES-DG, and low fault current for an inverter-based RES-DGs. This paper proposes a novel User-defined dual setting direction overcurrent relay with hybrid time current-voltage (UDDOR-TCV) characteristics to intensify the proposed scheme’s flexibility without any communication assistance for radial DN. The proposed model is formulated in a constrained non-linear optimization fashion and solved with the MINLP solver of general algebraic modelling system(GAMS) software to determine the optimal relay settings. The propounded protection scheme is simulated on IEEE-33 bus radial distribution system and a local 40-bus system hosting the multiple SCIG and PV based RES-DGs at optimal locations. Detailed numerical studies are carried out to show the performance of the proposed scheme. 66.848% and 68.26% reduction in relay operation time with zero mis-coordination is achieved with SCIG-WTG case and PV-units case for the IEEE-33 bus system and a similar reduction in operation time is 68.937% and 66.563% for Local-40 bus system. Moreover, the relays numbers are reduced by 32.692% and 39.7% for IEEE-33 and Local-40 bus systems, respectively, due to the forward/reverse characteristics capability of the proposed UDDOR-TCV. The performance of the proposed scheme is also evaluated on IEEE-8 bus meshed DN. The results are compared with the existing protection schemes in recent literature.
15 March 2022 in Physica A: Statistical Mechanics and its Applications
The recent advancement in the application of the internet of things in the smart grid has led to an industrial revolution in the power industry. The Industry 4.0 revolution has already set in, allowing computers to interact for an efficient and intelligent approach in solving smart grid issues. multilevel inverters (MLIs) are an integral part of the smart grid system for integrating the distributed generation sources and storage energy systems into the smart grid. It attracted attention in industrial applications as they can handle high power and high voltage with an inherent feature of superior output voltage waveform quality. Moreover, its variant, the switched-capacitor MLI (SCMLI), has the added benefit of lesser DC supply requirement. In this paper, a switched-capacitor multilevel inverter topology has been proposed, which can operate in symmetric and asymmetric mode. The proposed SCMLI generate thirteen and thirty-one level output voltages for symmetric and asymmetric selection of DC voltage sources, respectively. The proposed SCMLI has a smaller number of switching devices for a given output voltage level as compared to other recently proposed topologies. A thorough comparison is presented with the recently proposed topologies on several parameters, including cost function. To validate the proposed topology, symmetric and asymmetric cases were simulated using Matlab® 2018a and the results were verified using an experimental hardware setup.
Low-cost and washable resistive switching (RS) memory devices with stable retention and low operational voltage are important for higher speed and denser non-volatile memories. In the case of green electronics, pectin has emerged as a suitable alternative to toxic metal oxides for resistive switching applications. Herein, a pectin-based thin film was fabricated on a fluorine-doped tin oxide glass substrate for RS mechanism. The presence of sp3–C groups with low binding energy corresponds to tunable charged defects and the oxygen vacancies confirmed by the O 1s spectra that plays a decisive role in the resistive switching mechanism, as revealed by X-ray photoemission spectroscopy (XPS). The surface morphology of the pectin film shows homogeneous growth and negligible surface roughness (38.98 ± 9.09). The pectin film can dissolve in DI water (10 minutes) owing to its ionization of carboxylic groups, that meet the trends of transient electronics. The developed Ag/pectin/FTO-based memory cell exhibits stable and reproducible bipolar resistive switching behavior along with an excellent ON/OFF ratio (104) and negligible electrical degradation was observed over 30 repeated cycles. Hence, it appears to be a valuable application for green electronics. Indeed, biocompatible storage devices derived from natural pectin are promising for high-density safe applications for information storage systems, flexible electronics, and green electronics.
Clean water scarcity is still an intense, prolonged global issue that needs to be resolved urgently. The solar steam generation has shown great potential with a high energy conversion efficiency for clean water production from seawater and wastewater. However, the high evaporation rate of water cannot be preserved due to the inevitable fouling of solar absorbers. Herein, a self-floatable and super hydrophilic solar-driven steam generator composed of activated carbon coated melamine foam (ACM). The deposited ACM photothermal layer exhibits outstanding solar absorption (92%) and an efficient evaporation rate of 1.27 kg m−2 h−1, along with excellent photothermal conversion efficiency (80%) as compared to commercially available primitive solar stills. The open porous assembly of melamine foam equipped with 80% flexibility (0.8 MPa) enabled smooth water transport and sustain heat accumulation within the matrix. The thermal insulation of ACM is 10 times greater than pure water. Moreover, open porous assembly of designed solar-powered steam generator rejects salt ions as well as volatile organic compounds efficiently. The low-cost and facile fabrication of photothermal based water production presents a potential solution to single step drinking water supply from various resources of the sea, the lakes and mixtures of emulsified oil and industrial wastewater.
About Me
I want to benefit the world with my knowledge. Eradicating poverty and spread justice
I want to benefit the world with my knowledge. Eradicating poverty and spread justice