After decades of development of the vanadium titanomagnetite (VTM) ore in the Panzhihua district changes have taken place to the ore characteristics. In addition, preliminary research carried out in this area mainly focused on the separation and extraction of iron resources and lacked a systematic research focus on the process mineralogy of ilmenite, resulting in a low grade and yield of the separated ilmenite. Therefore, the present study investigates the compositions, textures, element distributions, and particle size characteristics of VTM ores in Panzhihua were studied via mineral dissociation analysis (MLA), electron microscope–microprobe analysis (EPMA), scanning electron microscopy (SEM), and X-ray diffraction (XRD). The results show that the chemical and mineral compositions of the VTM ore samples were basically stable. However, the size of the embedded particles of ilmenite and titanomagnetite was smaller than that reported previously. In addition, the olivine content was found to have significantly increased, and a large number of altered minerals (such as chlorite and sphene) were also present, as a result of which the degrees of monomer dissociation of ilmenite and titanomagnetite reached 85% when the fraction of particles with size in the range of 0.04–0.15 mm was 75%.
Titanium tetrachloride (TiCl4) is an important intermediate material for the preparation of titanium products. The organic impurities in TiCl4 are easily accumulated during the production of titanium sponges due to the problems of imperfect detection methods and the lack of effective control methods, resulting in a poor quality of sponge titanium. Among all impurities, chloroacetyl chloride (CAC) is the most important in TiCl4. Herein, the determination of the CAC content in TiCl4 solution, with a low detection limit of 0.633 ppm, was established by the standard addition method using Fourier transform infrared (FTIR) spectrometry. This test method presented good repeatability, excellent accuracy, and moderate precision. Furthermore, the influencing factors of CAC separation in the continuous rectification process, including the heating power (the ratio of total heating power to feed rate), reflux temperature, top tower pressure, and feed temperature were optimized based on an orthogonal experimental design. The experimental data demonstrated that the average CAC removal rate reached 78.94% ± 1.00% under the optimal distillation conditions, with 72.21% of the CAC removed via the off-gas system. Therefore, excellent control of the negative pressure of the tail gas is highly desirable for the removal of CAC impurities.