The local scour around bridge piers influences their stabilities and plays a key role in the bridge failures. The estimation of the maximum possible scour depth around bridge piers is an important step in the design of the bridge pier foundations. In this study, the temporal evolution of local scour depths as well as the equilibrium scour depths were analyzed. The experiments were carried out in a rectangular flume by using uniform sediment with median diameter of 3.5 mm and geometric standard deviation of 1.4. The diameters of the tested circular bridge piers were 40 mm, 80 mm, 150 mm and 200 mm. The flow and scour depths were determined by ultrasonic sensors. The experiments were realized in clear water conditions with various constant flow rates. The experimental findings were compared with those calculated from some empirical equations existing in the literature. A new empirical relation involving the flow intensity, the relative water depth and the dimensionless time is also introduced. The advantage of this proposed relation is that the only parameter requiring the calculation is the critical velocity, other parameters being known geometric and hydraulic parameters. The performance of this relation was tested by using experimental data available in the literature, and a satisfactory compatibility was revealed between the experimental and numerical results.
1 January 2013 in Journal of Hydraulic Engineering
Gravel-bed rivers display a surface layer that is coarser than the substrate lining below this armored surface. The armored layer that is developed under certain flow conditions may be attributed as water-worked sediment bed. Both the threshold of incipient motion and the bed-load transport are affected by the presence of this layer. In this study, the coarse surface development and its effect on the sediment transport were investigated experimentally in a rectangular flume. Four antecedent flow rates were combined with an input hydrograph, without sediment feeding. The reference shear stress of individual fractions and the grain-size distribution were determined after the development of the coarse surface due to the antecedent flow. Then a triangular-shaped hydrograph was generated for both the intact surface and the coarse surface cases. It was seen that the maximum bed-load transport values obtained in unsteady flow experiments were highly dependent on the coarse surface formed by the anteceden...
8 March 2016 in Theoretical and Applied Climatology
Ultrasonic Velocity Profiler (UVP) is a widely used instrument which allows the determination of the complete velocity profile. UVP can also measure the echo amplitude in the mean time. In this study, it is intended to use the UVP transducers in an indirect way to detect the bottom surface by orienting them vertically downward. Preliminary experiments were conducted with immobile bed by using uniform, non-uniform sediment as well as wooden and plastic surface. It was appeared that the first remarkable peak corresponds to the bottom surface. The time variations of local bed elevations were registered by applying this technique in order to determine the erosion and deposition around a bridge pier and local scour around a horizontal submerged pipe. It was revealed that the so registered scour depths were in good agreement with those observed during the experiments. Consequently, it is demonstrated that time varied bed elevations can be measured via the first peak value of echo amplitudes by placing UVP transducers vertically.