In this paper, a metal-dielectric-metal configuration is employed. The unit cell of the proposed chiral metamaterial design consists of a simple 'EI' shape resonator printed on two opposite sides of dielectric substrate. The metal pattern on the front and back layers is identical, with the exception that the back-layer pattern twisted at a 90o angle to break mirror symmetry in the propagation direction. The optimized dimensions (in mm) of the unit cell are: w=1.5, w1=1.5, d=1, b=6, m=3, h=1.6 and a=8. The dielectric substrate is Roger 5080, which has a dielectric constant εr = 2.33, and tangent loss tan δ = 0.0005. The copper sheet is used as a metallic pattern having a thickness of 35um, and an electrical conductivity of 5.8 x 107 S/m. Commercially available software called CST Microwave Studio is used to carry out the numerical simulations of the suggested design. Unit-cell boundary conditions were applied in the y- and x-directions, while open boundary conditions were used in the z-direction. The numerical simulation is carried out in the frequency range of 11 GHz to 23 GHz. Through numerical simulation, complex transmission coefficients are produced, from which the asymmetric transmission, total transmission and polarization conversion ratio are calculated. The simulation results of complex transmission coefficients for linearly polarized waves in the forward (+z) and backward (-z) direction of propagation shows wide, strong peaks.
In this study, the design of a dual-band terahertz absorber, previously published by Lu et al. (Symmetry 2018, 10, 293), was re-simulated. Our findings showed significantly different absorption results from those published in the article. A detailed analysis was conducted to explain this discrepancy, which was attributed to the reflection of an unaccounted orthogonal component of the waves from the design, rather than absorption. The metasurface design has two resonances at 4.48 THz and 4.76 THz, respectively. It was reported that at these frequencies, the structure achieved absorption of 98.6% and 98.5%, respectively. However, in our results, it was found that at the second resonance (4.76 THz), the structure acted as a strong cross-polarization converter, reflecting a significant amount of incident energy in the cross-polarization component of the reflected wave. When this component is considered in the reflection coefficient calculations, the absorption reduces to 41% (from 98.5%), which is not an acceptable level for an absorber. In addition, the structure was simulated for both lossy and lossless (FR4) substrate cases to understand the effect of substrate losses. The results showed that the absorption response significantly deteriorates at the first resonance (4.48 THz) in the case of a lossy FR4 substrate.