This study produces alteration mineral maps based on WorldView-3 (WV-3) data and field shortwave-infrared (SWIR) spectroscopy. It is supported by conventional analytical methods such as X-ray diffraction, X-ray fluorescence, and electron probe X-ray micro analyzer as an initial step for mineral exploration in eastern Tsogttsetsii, Mongolia, where access is limited. Distributions of advanced argillic minerals (alunite, dickite, and kaolinite), illite/smectite (illite, smectite, and mixed-layered illite-smectite), and ammonium minerals (buddingtonite and NH4-illite) were mapped using the decorrelation stretch, band math, and mixture-tuned-matched filter (MTMF) techniques. The accuracy assessment of the WV-3 MTMF map using field SWIR data showed good WV-3 SWIR data accuracy for spectrally predominant alteration minerals such as alunite, kaolinite, buddingtonite, and NH4-illite. The combination of WV-3 SWIR mineral mapping and a drone photogrammetric-derived digital elevation model contributed to an understanding of the structural development of the hydrothermal system through visualization of the topographic and spatial distribution of surface alteration minerals. Field SWIR spectroscopy provided further detailed information regarding alteration minerals such as chemical variations of alunite, crystallinity of kaolinite, and aluminum abundance of illite that was unavailable in WV-3 SWIR data. Combining WV-3 SWIR data and field SWIR spectroscopy with conventional exploration methods can narrow the selection between deposit models and facilitate mineral exploration.
On 15 November 2017, liquefaction phenomena were observed around the epicenter after a 5.4 magnitude earthquake occurred in Pohang in southeast Korea. In this study, we attempted to detect areas of sudden water content increase by using SAR (synthetic aperture radar) and optical satellite images. We analyzed coherence changes using Sentinel-1 SAR coseismic image pairs and analyzed NDWI (normalized difference water index) changes using Landsat 8 and Sentinel-2 optical satellite images from before and after the earthquake. Coherence analysis showed no liquefaction-induced surface changes. The NDWI time series analysis models using Landsat 8 and Sentinel-2 optical images confirmed liquefaction phenomena close to the epicenter but could not detect liquefaction phenomena far from the epicenter. We proposed and evaluated the TDLI (temporal difference liquefaction index), which uses only one SWIR (short-wave infrared) band at 2200 nm, which is sensitive to soil moisture content. The Sentinel-2 TDLI was most consistent with field observations where sand blow from liquefaction was confirmed. We found that Sentinel-2, with its relatively shorter revisit period compared to that of Landsat 8 (5 days vs. 16 days), was more effective for detecting traces of short-lived liquefaction phenomena on the surface. The Sentinel-2 TDLI could help facilitate rapid investigations and responses to liquefaction damage.
Numerous reports have successfully detected or differentiated carbonate minerals such as calcite and dolomite by using the Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER). However, there is a need to determine whether existing methods can differentiate magnesite from other carbonate minerals. This study proposes optimal band ratio combinations and new thresholds to distinguish magnesite, dolomite, and calcite using ASTER shortwave-infrared (SWIR) data. These were determined based on the spectral and chemical analysis of rock samples collected from Liaoning, China and Danchon, North Korea and the reflectance values from ASTER images. The results demonstrated that the simultaneous use of thresholds 2.13 and 2.015 for relative absorption band depths (RBDs) of (6 + 8)/7 and (7 + 9)/8, respectively, was the most effective for magnesite differentiation. The use of RBDs and band ratios to discriminate between dolomite and calcite was sufficiently effective. However, talc, tremolite, clay, and their mixtures with dolomite and calcite, which are commonly found in the study area, hampered the classification. The assessment of the ASTER band ratios for magnesite grade according to magnesium oxide content indicated that a band ratio of 5/6 was the most effective for this purpose. Therefore, this study proved that ASTER SWIR data can be effectively utilized for the identification and grade assessment of magnesite on a regional scale.
31 December 2020 in Journal of the Geological Society of Korea
지상기반 초분광 영상 기술을 이용해 경기광업과 가사리 탄산염암 노두를 대상으로 광물 탐지 성능을 평가하고 광물 분포도를 작성하였다. 연속체 제거 기법은 CO₃, Al-OH에 의한 광물 고유의 흡수 특징을 쉽고 빠르게 탐지할 수 있었지만 세분화된 광물 분류는 어려웠다. 반면 다중 범위 분광특징근사 기법은 백운석, 방해석, 마그네사이트와 같은 탄산염 광물들 뿐만 아니라 고령석, 일라이트와 같은 층상 규산염 광물들을 세부적으로 분류할 수 있었다. 현장 관찰과 암석시료에 대한 X선 회절 분석 및 분광측정 결과들은 초분광 영상을 이용한 탄산염 광물 분류 결과에 대한 높은 정확도를 보여준다. 초분광 영상으로부터 획득되는 분광학적 특징들은 탄산염 광물의 유기물 함량, 입자크기, 분급, 다공성과 같은 물리적, 화학적 특성과 관련이 있기 때문에 초분광 영상기술은 탄산염 노두를 해석하는데 있어 현장 관찰과 화학분석과 같은 전통적 탐사기법과 함께 상호보완적으로 활용될 수 있을 것이다. 지상기반 초분광 영상 기술은 특히 직접적인 조사가 어려운 높은 수직 노두에 대해 광물 정보를 얻거나 층서 및 구조 분석과 관련된 지질매핑이나 해석을 할 때 효과적으로 사용 될 수 있을 것으로 보인다.