In recent years, because of highly developed LiDAR (Light Detection and Ranging) technologies, there has been increasing demand for 3D change detection in urban monitoring, urban model updating, and disaster assessment. In order to improve the effectiveness of 3D change detection based on point clouds, an approach for 3D change detection using point-based comparison is presented in this paper. To avoid density variation in point clouds, adaptive thresholds are calculated through the k-neighboring average distance and the local point cloud density. A series of experiments for quantitative evaluation is performed. In the experiments, the influencing factors including threshold, registration error, and neighboring number of 3D change detection are discussed and analyzed. The results of the experiments demonstrate that the approach using adaptive thresholds based on local point cloud density are effective and suitable.

Monitoring the work cycles of earthmoving excavators is an important aspect of construction productivity assessment. Currently, the most advanced method for the recognition of work cycles is the “Stretching-Bending” Sequential Pattern (SBSP), which is based on fixed-carrier video monitoring (FC-SBSP). However, the application of this method presupposes the availability of preconstructed installation carriers to act as a surveillance camera as well as installed and commissioned surveillance systems that work in tandem with them. Obviously, this method is difficult to apply to projects with no conditions for a monitoring camera installation or which have a short construction time. This highlights the potential application of Unmanned Aerial Vehicle (UAV) remote sensing, which is flexible and mobile. Unfortunately, few studies have been conducted on the application of UAV remote sensing for the work cycle monitoring of earthmoving excavators. This research is necessary because the use of UAV remote sensing for monitoring the work cycles of earthmoving excavators can improve construction productivity and save time and costs, especially in post-disaster reconstruction projects involving harsh construction environments, and emergency projects with short construction periods. In addition, the challenges posed by UAV shaking may have to be taken into account when using the SBSP for UAV remote sensing. To this end, this study used application experiments in which stabilization processing of UAV video data was performed for UAV shaking. The application experimental results show that the work cycle performance of UAV remote-sensing-based SBSP (UAV-SBSP) for UAV video data was 2.45% and 5.36% lower in terms of precision and recall, respectively, without stabilization processing than after stabilization processing. Comparative experiments were also designed to investigate the applicability of the SBSP oriented toward UAV remote sensing. Comparative experimental results show that the same level of performance was obtained for the recognition of work cycles with the UAV-SBSP as compared with the FC-SBSP, demonstrating the good applicability of this method. Therefore, the results of this study show that UAV remote sensing enables effective monitoring of earthmoving excavator work cycles in construction sites where monitoring cameras are not available for installation, and it can be used as an alternative technology to fixed-carrier video monitoring for onsite proximity monitoring.