In this paper, the design of a flexible piston accumulator for application in a hydraulic-pneumatic flywheel system in a wind turbine rotor is presented. The flywheel system enables a wind turbine to vary the inertia of its rotor blades to control the power output and, most importantly, to influence the vibratory behaviour of wind turbine components. The method used for designing the flexible accumulator is based on the one hand on test results of a flexible piston accumulator prototype, and on the other hand, on simulation results of a model of a flexible piston accumulator. As a result, a design of flexible piston accumulators for application in the flywheel system is implemented and compared with the design of conventional steel accumulators. Due to the proposed design of the flywheel system, the impact on the mechanical loads of a wind turbine is analysed. The simulation results show that the new design of the piston accumulators causes a lower impact on the mechanical loads of the wind turbine than a previously published design of piston accumulators. It is further shown that the considered wind turbine can take on the flywheel system without the need for reinforcements in the rotor blades.
Heavy-duty vehicles cause a significant percentage of the harmful gas emissions from the automotive industry. This article presents the development of a compression system for hydrogen as part of the H2REF-DEMO hydrogen refueling station, joining the European efforts to promote hydrogen (H2) as a fuel that can play a key role in the energy transition of these types of vehicles. The H2REF-DEMO project, co-funded by the European Union’s “Horizon. Europe” programme under the “Clean Hydrogen Partnership” (grant agreement no. 101101517), involves a partnership between companies and research centers that aims to investigate the possibility of compressing hydrogen through hydraulic power to handle large vehicle refueling applications, such as bus fleet depots, trucks, or trains. The basic principle is the exploitation of hydraulic power to compress hydrogen through hydro-pneumatic bladder accumulators. The hydraulic power units, in fact, pump oil into the accumulators, causing a deformation of the bladder containing H2 and thus a consequent gas compression. In this article, we focus on the development of the compression system, from the theoretical starting point to the core final layout of the refueling station for large vehicles. We also exploit a lumped parameter numerical model to both support the system design and virtually test its first control logic. The latter, in particular, allows the system to operate in three modes—Bypass, Parallel, and Serial modes—thus leaving room for testing basic and more complex control strategies. The results of numerical simulations demonstrate the effectiveness of this innovative compression technology and its considerable efficiency in terms of refueling time and energy consumption, especially when compared to the standard systems used for this application. These are thus encouraging results that can support the development of an actual H2REF-DEMO hydraulic test rig for hydrogen compression.
New axial piston pumps with fixed displacement volumes, such as the high efficient power package (HEPP) pumps, operate at variable rotational speeds and thus variable flow rates in a wide range. Using intelligent pump control systems, small and light packages are possible. In contrast, the frequency of the fluid pulsations vary due to the rotational speed and have to be controlled avoiding stress or wear in the hydraulic system components (e.g. seals of tubing) and potentially impacting noise emissions. Especially in mobile machines, the noise of a combustion engine drown out the noise of the hydraulic system. By replacing the combustion engines by electric drives, the fluid born noise (FBN) becomes audible. Due to the excitation frequencies, a broadband silencer for high-pressure applications is required. This is realized by a Multi-Helmholtz-Resonator (MHR) concept within one cylindrical volume. The design will be adapted for pump-specific frequency characteristics in aircraft hydraulic conditions and fine adjusted during test verification by means of an adjustable tube-inside a pressure shell.