There are many advantages to adhesively bonding stiffeners onto aircraft structures rather than using traditional mechanical fastening methods. However there is a lack of confidence of the structural integrity of adhesively bonded joints over time. Acousto-ultrasonic Lamb waves have shown great potential in structural health monitoring applications in both metallic and composite structures. This paper presents an experimental investigation of the use of acousto-ultrasonic Lamb waves for the monitoring of adhesively bonded joints in metallic structures using 3D scanning laser vibrometry. Two stiffened panels were manufactured, one with an intentional disbonded region. Lamb wave interaction with the healthy and disbonded stiffeners was investigated at three excitation frequencies. A windowed root-mean-squared technique was applied to quantify where Lamb wave energy was reflected, attenuated and transmitted across the structure enabling the size and shape of the defect to be visualised which was verified by traditional ultrasonic inspection techniques.
6 December 2016 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
As worldwide wind energy generation capacity grows, there is an increasing demand to ensure structural integrity of the turbine blades to maintain efficient and safe energy generation. Currently, traditional non-destructive testing methods and visual inspections are employed which require the turbine to be out-of-operation during the inspection periods, resulting in costly and lengthy downtime. This study experimentally investigates the potential for using Lamb waves to monitor the structural integrity of a composite wind turbine blade that has been subject to an impact representative of damage which occurs in service. 3D scanning laser vibrometry was used to measure Lamb waves excited at three different frequencies both prior to, and after, impact to identify settings for an optimal system. Signal processing techniques were applied to the datasets to successfully locate the damage and highlight regions on the structure where the Lamb wave was significantly influenced by the presence of the impact damage. Damage size resulting from the impact was found to correlate well with the laser vibrometry results. The study concluded that acousto-ultrasonic-based structural health monitoring systems have great potential for monitoring the structural integrity of wind turbine blades.
16 November 2017 in International Journal of Distributed Sensor Networks
Aircraft structural damage detection is becoming of increased importance. Technologies such as acousto-ultrasonic have been suggested for this application; however, an optimization strategy for sensor network design is required to ensure a high detection probability while minimizing sensor network mass. A methodology for optimizing acousto-ultrasonic transducer placement for adhesive disbond detection on metallic aerospace structures is presented. Experimental data sets were acquired using three-dimensional scanning laser vibrometry enabling in-plane and out-of-plane Lamb wave components to be considered. This approach employs a novel multi-sensor site strategy which is difficult to achieve with physical transducers. Different excitation frequencies and source–damage–sensor paths were considered. A fitness assessment criterion which compared baseline and damaged data sets using cross-correlation coefficients was developed empirically. Efficient sensor network optimization was achieved using a bespoke genetic algorithm for different network sizes with the effectiveness assessed and discussed. A comparable numerical data set was also produced using the local interaction simulation approach and optimized using the same methodology. Comparable results with those of the experimental data set indicated a good agreement. As such, the numerical approach demonstrates that acousto-ultrasonic sensor networks can be optimized using simulation (with some further refinement) during an aircraft design phase, being a useful tool to sensor network designers.