The design and performance of a miniaturized coplanar capacitive sensor is presented whose electrode arrays can also function as resistive microheaters for thermocapillary actuation of liquid films and droplets. Optimal compromise between large capacitive signal and high spatial resolution is obtained for electrode widths comparable to the liquid film thickness measured, in agreement with supporting numerical simulations which include mutual capacitance effects. An interdigitated, variable width design, allowing for wider central electrodes, increases the capacitive signal for liquid structures with non-uniform height profiles. The capacitive resolution and time response of the current design is approximately 0.03 pF and 10 ms, respectively, which makes possible a number of sensing functions for nanoliter droplets. These include detection of droplet position, size, composition or percentage water uptake for hygroscopic liquids. Its rapid response time allows measurements of the rate of mass loss in evaporating droplets.

Open microfluidic devices based on actuation techniques such as electrowetting, dielectrophoresis, or thermocapillary stresses require controlled motion of small liquid droplets on the surface of glass or silicon substrates. In this article we explore the physical mechanisms affecting thermocapillary migration of droplets generated by surface temperature gradients on the supporting substrate. Using a combination of experiment and modeling, we investigate the behavior of the threshold force required for droplet mobilization and the speed after depinning as a function of the droplet size, the applied thermal gradient and the liquid material parameters. The experimental results are well described by a hydrodynamic model based on earlier work by Ford and Nadim. The model describes the steady motion of a two-dimensional droplet driven by thermocapillary stresses including contact angle hysteresis. The results of this study highlight the critical role of chemical or mechanical hysteresis and the need to reduce this retentive force for minimizing power requirements in microfluidic devices.

The thermoelectric power of a material, typically governed by its band structure and carrier density, can be varied by chemical doping that is often restricted by solubility of the dopant. Materials showing large thermoelectric power are useful for many industrial applications, such as the heat-to-electricity conversion and the thermoelectric cooling device. Here we show a full electric-field tuning of thermoelectric power in a dual-gated bilayer graphene device resulting from the opening of a band gap by applying a perpendicular electric field on bilayer graphene. We uncover a large enhancement in thermoelectric power at a low temperature, which may open up a new possibility in low temperature thermoelectric application using graphene-based device.

This paper reports the formation of two-dimensional electron gas (2DEG) in rf-sputtered defective polycrystalline MgZnO/ZnO heterostructure via the screening of grain boundary potential by polarization-induced charges. As the MgZnO thickness increases, the sheet resistance reduces rapidly and then saturates. The enhancement of the interfacial polarization effect becomes stronger, corresponding to a larger amount of resistance reduction, when the Mg content in the cap layer increases. Monte Carlo method by including grain boundary scattering effect as well as 2D finite-element-method Poisson and drift-diffusion solver is applied to analyze the polycrystalline heterostructure. The experimental and Monte Carlo simulation results show good agreement. From low temperature Hall measurement, the carrier density and mobility are both independent of temperature, indicating the formation of 2DEG with roughness scattering at the MgZnO/ZnO interface.