Comparative statistical analysis of the infiuence of processing parameters, for electrospinning (ES) and solution blow spinning (SBS) processes, on nanofibrous poly(L-lactic acid) (PLLA) material morphology and average fiber diameter was conducted in order to identify the key processing parameter for tailoring the product properties. Further, a comparative preliminary biocompatibility evaluation was performed. Based on Design of Experiment (DOE) principles, analysis of standard effects of voltage, air pressure, solution feed rate and concentration, on nanofibers average diameter was performed with the Pareto’s charts and the best fitted surface charts. Nanofibers were analyzed by scanning electron microscopy (SEM). The preliminary biocompatibility comparative tests were performed based on SEM microphotographs of CP5 cells cultured on materials derived from ES and SBS. Polymer solution concentration was identified as the key parameter infiuencing morphology and dimensions of nanofibrous mat produced from both techniques. In both cases, when polymer concentration increases the average fiber diameter increase. The preliminary biocompatibility test suggests that nanofibers produced by ES as well as SBS are suitable as the biomedical engineering scaffold material.
14 November 2014 in Plant Cell, Tissue and Organ Culture (PCTOC)
Enhanced taxane production was observed in a hybrid, two liquid phases containing, cultures of Taxus x media var. Hicksii hairy root carrying a taxadiene synthase transgene, supported with liquid perfluorodecalin (PFD) in degassed or aerated form. The hairy root cultures were elicited with methyl jasmonate (MJ, 100 μM) or coronatine (COR, 1 μM), and fed with sucrose and l-phenylalanine. The root growth was not stimulated by PFD addition, irrespective of the day of its application (day 0 and 14). However, in the cultures elicited with MJ and performed in the presence of PFD the final root biomass accumulation was higher than in cultures performed without PFD while the opposite effect was observed in cultures supplemented with COR. The highest paclitaxel content in root biomass was determined at the end of the cultures elicited with MJ and supplemented with PFD-degassed at day 0 or 14, 1,440.8 and 1,432.5 μg g−1 DW, respectively. The highest total (i.e. intracellular + extracellular: both in aqueous and PFD phases) paclitaxel yield in flasks (149.15 μg flask−1) was noted after the application of PFD-degassed at day 14. The other taxane detected was baccatin III, only in the root biomass, with the highest content (76.9 μg g−1 DW) observed under COR treatment. Although COR stimulated paclitaxel production with less efficiency than MJ, it resulted in higher paclitaxel excretion to the liquid phases of culture medium and PFD.
1 August 2018 in Chemical Engineering Research and Design
Adherent A431, BHK-21, and C2C12 cells were cultured on a flexible interface formed between two immiscible liquid phases: (i) hydrophobic perfluorodecalin (PFD) and (ii) aqueous culture medium (DMEM). BHK-21 cells formed multicellular aggregates characterized by irregular shapes. A431, as well as C2C12 cells, grew as tight multicellular sheets of 3-D cells. Enhanced mass transfer and facilitated access of the cells to the O2 dissolved in PFD/DMEM by approx. 250 % and thereby increased the density of BHK-21 cells. Thus the liquid/liquid system is a simple, ready-to-use, and fully scalable (independent of vessel shapes); consequently it is a method for 3-D cultures of adherent animal cells in which the growth of anchorage-dependent cells is not limited by confluence effect.
1 August 2011 in Sensors and Actuators B: Chemical