The utility of constant blowing as an aerodynamic load control concept for wind turbine blades was explored experimentally. A NACA 0018 airfoil model equipped with control slots near the leading edge and at mid-chord was investigated initially under quasi-static conditions at Reynolds numbers ranging from 1.25·105 to 3.75·105. Blowing from the leading-edge slot showed a significant potential for load control applications. Leading-edge stall was either promoted or inhibited depending on the momentum coefficient, and a corresponding reduction or increase in lift on the order of Δcl≈0.5 was obtained. Control from the mid-chord slot counteracted trailing-edge stall but was ineffective at preventing leading-edge separation. The impact of blowing from the leading-edge slot on dynamic stall was explored by means of unsteady surface pressure measurements and simultaneous particle image velocimetry above the suction surface. At a sufficiently high momentum coefficient, the formation and shedding of the dynamic sta...
The mechanism of flow separation control was investigated experimentally and computationally using pulse-modulated dielectric barrier discharge (DBD) plasma actuation on a stalled flat plate airfoil at a Reynolds number of 3000. Load measurements were complimented with two-dimensional phase-averaged particle image velocimetry performed in the flowfield above the airfoil. A parametric study was carried out where the pulse-modulation frequency, duty cycle, and peak plasma body-force were varied. The two-dimensional Navier-Stokes equations, with no turbulence modeling, were solved directly using a commercial flow solver and a simple but satisfactory heuristic DBD plasma body-force model was incorporated. The overall experimental trends were well predicted by the computations, where the frequencies that produced the largest increases in lift coefficient excited bluff-body shedding at a frequency corresponding approximately to its unforced sub-harmonic. At non-dimensional frequencies most effective for increasing lift (∼0.2 to 0.5), the leading-edge shear layer was severed by the perturbations and then merged with a downstream vortex. In a time-mean sense this mechanism forced relatively high momentum fluid towards the surface with typically two re-circulating structures present on the airfoil. Although the essential flow control mechanism was captured by the computation, the idealized 2D approach was identified as a weakness due to the shedding instability not being present in the baseline experiments and the inability to account for three-dimensional structures in the shear layer.
A theory based upon linearized governing equations is developed that describes the operation principles and design parameters for low-speed wind tunnels with longitudinal freestream oscillations. Existing measurements made in unsteady wind tunnels are shown to be consistent with the theory and targeted validation experiments performed in a variable-geometry blowdown-type wind tunnel revealed excellent correspondence with the theoretical results. In particular, the tunnel frequency bandwidth is proportional to the mean tunnel freestream velocity and inversely proportional to the test-section length and the square of the exit area to test-section area ratio. The acoustics equations reveal a “Helmholtz damping ratio” that is not only dependent on the tunnel geometry and exit area but also proportional to the freestream Mach number. At appreciable reduced frequencies, dynamic stall on the louver vanes increases pressure losses, thereby reducing the mean flow speeds. Varying the exit area results in louver-vane vortex shedding that can excite resonances, resulting in an apparent increase in the turbulence level. To achieve large freestream amplitudes and high-frequency bandwidths, substantial blockage, and therefore pressure losses, will be incurred; thus, large increases in the tunnel power factor should be anticipated.