Successful operation of 4H-silicon carbide (SiC) MOSFET and integrated electronic circuit based on 4H-SiC MOSFET is reported at temperature up to $500~^{\circ }\text{C}$ in air. The high-temperature operation of the integrated circuit (IC) based on 4H-SiC MOSFET strongly depends on the reliability of metal/SiC contact. Based on the transfer length method (TLM), the Ni/Nb/n-type 4H-SiC junction exhibits ohmic behavior with specific contact resistance of $1.86\times 10^{-{4}}\,\, \Omega \cdot $ cm 2 when operating at $500~^{\circ }\text{C}$ . In contrast, the voltage gain of the amplifier is strongly governed by the variation of carrier mobility of the 4H-SiC MOSFET when temperature varies from room temperature to $500~^{\circ }\text{C}$ . The experimental results show that, when the temperature is increased from $20~^{\circ }\text{C}$ to $300~^{\circ }\text{C}$ , the amplifier gain of the IC increased from 23.8 to 153.0. Though the voltage gain decreases when the temperature increases above $300~^{\circ }\text{C}$ , it is still higher than 50 at $500~^{\circ }\text{C}$ . These results indicate that integrated electronic circuits based on this 4H-SiC MOSFET technology could be potentially used for harsh environment applications.
Epitaxial Ti-Si-C Ohmic contacts on the 4H-SiC C-face for SiC power devices by pulsed-laser annealing were demonstrated. Titanium (Ti) is one of the carbon-interstitial type metals. In a conventional nickel silicide (NiSi) electrode on SiC, carbon agglomeration at the silicide/SiC interface occurs, and the contact resistance between NiSi and SiC substrates becomes larger. For the carbon agglomeration suppression, a nanosecond non-equilibrium laser annealing was performed, and also Ti was deposited for the formation of both silicide and carbide. As a result, the lowest specific contact resistance of 4.0 × 10−4 Ω cm2 was obtained for an Al/Ti-Si-C/SiC structure at a laser power of 2.5 J/cm2. The Ti-Si-C Ohmic electrode showed TiC and Ti5Si3 crystal phases, and these crystals were epitaxially grown on 4H-SiC at the interface.
A multiline beam continuous-wave laser lateral crystallization (MLB-CLC) method was developed to realize a predominantly (100)-oriented polycrystalline silicon (poly-Si) film with a high biaxial tensile strain. Low-temperature poly-Si (LTPS) thin film transistors (TFTs) with an ultrahigh maximum electron field effect mobility of 1010 cm2 V−1 s−1 were realized. The correlation between the performance and microscopic crystallinity of the TFTs was investigated. The performance enhancement of TFTs brings about highly (100)-surface-oriented large Si crystallites with a high biaxial tensile strain and grain boundaries being parallel to the current flow.
For radiation-hardened CMOS image sensor (CIS), 4H-SiC photosensors with active pixel sensor (APS)-type circuits were developed and demonstrated. The dark current of 4H-SiC photodiodes was <2 nA/cm2. The spectral sensitivity characteristics were also evaluated in the wavelength from 200 nm to 400 nm. The maximal quantum efficiency was 63% at 270 nm. The photosensors with APS type circuits showed high responses to UV light, demonstrating their operation. High gamma-ray dose experiments were also carried out. The dark current after 2 MGy (SiO2) irradiation was 25 nA/cm2. The photosensors with APS-type were successfully working after 2 MGy exposure.
25 November 2020 in Japanese Journal of Applied Physics
The high-temperature reliability of integrated circuit based on 4H-SiC MOSFET with Ni/Nb ohmic contacts was investigated at 400 °C in N 2 ambient. The results showed that the single stage amplifier remained a stable voltage gain after 100 h of aging at 400 °C. Based on the transfer length method, the Ni/Nb/n-type 4H-SiC ohmic contact exhibited the excellent stability after being aged at 400 °C for 100 h. Whereas, the stability of electrical characteristics indicated that the 4H-SiC MOSFET also exhibited a good stability when operating in high temperature environment. Moreover, the stability of the electrical characteristics of the 4H-SiC MOS capacitor showed that the reliability of the Ni/Nb/4H-SiC ohmic contact played important role in reliability of SiC based devices. These results indicate that the fabrication process of the integrated circuits based on 4H-SiC devices with Ni/Nb ohmic contacts is promising to apply for high temperature as well as harsh environment applications.