Current research trends have advanced the use of “green propellants” on a wide scale for spacecraft in various space missions; mainly for environmental sustainability and safety concerns. Small satellites, particularly micro and nanosatellites, evolved from passive planetary-orbiting to being able to perform active orbital operations that may require high-thrust impulsive capabilities. Thus, onboard primary and auxiliary propulsion systems capable of performing such orbital operations are required. Novelty in primary propulsion systems design calls for specific attention to miniaturization, which can be achieved, along the above-mentioned orbital transfer capabilities, by utilizing green monopropellants due to their relative high performance together with simplicity, and better storability when compared to gaseous and bi-propellants, especially for miniaturized systems. Owing to the ongoing rapid research activities in the green-propulsion field, it was necessary to extensively study and collect various data of green monopropellants properties and performance that would further assist analysts and designers in the research and development of liquid propulsion systems. This review traces the history and origins of green monopropellants and after intensive study of physicochemical properties of such propellants it was possible to classify green monopropellants to three main classes: Energetic Ionic Liquids (EILs), Liquid NOx Monopropellants, and Hydrogen Peroxide Aqueous Solutions (HPAS). Further, the tabulated data and performance comparisons will provide substantial assistance in using analysis tools—such as: Rocket Propulsion Analysis (RPA) and NASA CEA—for engineers and scientists dealing with chemical propulsion systems analysis and design. Some applications of green monopropellants were discussed through different propulsion systems configurations such as: multi-mode, dual mode, and combined chemical–electric propulsion. Although the in-space demonstrated EILs (i.e., AF-M315E and LMP-103S) are widely proposed and utilized in many space applications, the investigation transpired that NOx fuel blends possess the highest performance, while HPAS yield the lowest performance even compared to hydrazine.
A number of platinum catalysts for the decomposition of 98% hydrogen peroxide, based on different substrates, geometries, and sizes, have been prepared using different procedures. The catalysts have undergone a set of dedicated tests for screening their catalytic activity and their thermomechanical resistance in order to identify the most efficient and suitable catalyst to be used for a pulsed monopropellant propulsion system. An experimental test campaign on a 20 N monopropellant thruster prototype has been carried out with the aim of assessing the capability of the finally selected new catalysts of effectively decomposing 98% hydrogen peroxide and the attainable propulsive performance in steady-state conditions for the future assessment of the propulsive performance of the intrinsically unsteady new propulsion concept. The catalysts have been able to decompose up to 1 liter of 98% with very good efficiencies ( and ) and without any pellet breakage or catalytic degradation. The thrust profile has been particularly smooth and the experimental specific impulse measured at sea level with the matched conical nozzle has been 130 s, which corresponds to an extrapolated vacuum specific impulse for a high-expansion-area-ratio bell-contoured nozzle higher than 185 s.
The present paper describes a steady one dimensional model of the hydrogen peroxide decomposition flow in a pellet-type catalytic bed and its application to the parametric design of a typical reactor for small rocket propellant thrusters. The two-phase liquid-gas-vapor flow through the bed is treated as a homogeneous, adiabatic, chemically reacting flow, for which the properties depend on the local composition. Fast equilibrium hydrogen peroxide adsorption and first-order finite-rate desorption is assumed for the one-step hydrogen peroxide decomposition reaction on the catalyst surface. Standard viscous/aerodynamic correlations for porous media are used to account for pressure losses. The predictions of the model depend on a limited number of uncertain parameters, for which the values can be readily determined by comparison with the available experimental data. Good agreement has been attained between the model predictions and the results of hydrogen peroxide monopropellan..
1 November 2009 in Journal of Propulsion and Power