A convenient method for the preparation of polybasic ternary hybrid cryogels consisting of Halloysite nanotubes (HNTs) and tertiary amine functional groups by freezing-induced gelation is proposed. Ternary hybrid gels were produced via one-shot radical terpolymerization of 2-hydroxyethyl methacrylate (HEMA), 2-acrylamido-2-methyl-1-propane sulfonic acid (AMPS), and DEAEMA in the presence of HNTs. The equilibrium swelling in various swelling media and the mechanical properties of the produced ternary hybrid gels were analyzed to investigate their network structure and determine their final performance. The swelling ratio of HNT-free gels was significantly higher than the ternary hybrid gels composed of high amount of HNTs. The addition of HNTs to terpolymer network did not suppress pH- and temperature-sensitive behavior. While DEAEMA groups were effective for pH-sensitive swelling, it was determined that both HEMA and DEAEMA groups were effective in temperature-sensitive swelling. Ternary hybrid gels simultaneously demonstrated both negative and positive temperature-responsive swelling behavior. The swelling ratio changed considerably according to swelling temperature. Both DEAEMA and HEMA monomers in terpolymer structure were dominant in temperature-sensitive swelling. Mechanical tests in compression of both as-prepared and swollen-state demonstrated that strength and modulus of hybrid cryogels significantly increased with addition of HNTs without significant loss of mechanical strength. Ultimately, the results of the current system can benefit characterization with analysis tools for the application of innovative materials.
This article addresses various strategies that have been explored to design sulfonated poly(dimethylaminoethyl methacrylate)/mica hybrid-gels with optimized network parameters and mechanical/swelling properties. A series of hybrid cryogels and hydrogels containing amino and sulfonic acid groups were prepared from N,N-dimethylaminoethyl methacrylate (DMAEMA) and 2-acrylamido-2-methyl-1-propane sulfonic acid in the presence of inorganic additive mica via a cryogelation process and conventional in situ copolymerization. Cryogelation was used to fine-tune the mechanical properties of the PDMAEMA-based hybrid gels. The effects of pH, temperature and mica content on the network parameters, mechanical properties and swelling behavior were discussed. X-ray diffractometry and Fourier transform infrared spectroscopy confirmed that mica particles had participated in (cryo)polymerization, and the thermal stability and surface morphologies were improved by the addition of mica. The profile of water loss, decomposition of amine groups and breakdown of PDMAEMA chains of the resulting hybrid gels were determined by thermogravimetric analysis. A critical mica concentration was found for the hybrid hydrogels where the degree of swelling attains a maximum value. Below 0.50% (w/v) of mica, the ionic nature of mica dominates its crosslinker effect. The hybrid cryogels were tough and able to recover at room temperature after compression testing. The prepared hybrid-gels showed an enhanced swelling response and on–off switching swelling characteristics in water and in aqueous NaCl solutions. The parameters of equilibrium swelling, the initial swelling rate, the diffusional exponent, and the diffusion coefficient were evaluated and the swelling kinetics of the hybrid hydrogels and cryogels in water followed the pseudo second order model. All the prepared hybrid hydrogel and cryogel materials with tunable mechanical stability and elasticity can be excellent candidates for designing smart materials.