The development of electric vehicles and portable electronic devices demands lighter and thinner batteries with improved specific charge and rate capabilities. In this work, thin films of LiMn 2 O 4 were fabricated by rf magnetron sputtering. Glancing angle deposition is introduced as a promising approach for fabrication of porous cathode thin films with 2.6 times the capacity in comparison with conventionally sputtered films of the same thickness. Surface morphology and crystallinity of the films are studied along with their electrochemical performance in an aqueous electrolyte. The glancing angle deposited films can reach a rate capability of up to 4 mA cm −2 with minimal energy loss, and a life cycle longer than 100 charge/discharge cycles.
The crystal orientation and morphology of sputtered LiMn 2 O 4 thin films is strongly affected by the current collector. By substituting Pt with Au, it is possible to observe in the x-ray diffraction pattern of LiMn 2 O 4 a change in the preferential orientation of the grains from (111) to (400). In addition, LiMn 2 O 4 thin films deposited on Au show a higher porosity than films deposited on Pt. These structural differences cause an improvement in the electrochemical performances of the thin films deposited on Au, with up to 50% more specific charge. Aqueous cells using thin film based on LiMn 2 O 4 sputtered on Au or Pt as the cathode electrode present a similar retention of specific charge, delivering 85% and 100%, respectively, of the initial values after 100 cycles. The critical role of the nature of the substrate used in the morphology and electrochemical behaviour observed could permit the exploration of similar effects for other lithium intercalation electrodes.
1 December 2020 in International Journal of Hydrogen Energy