Maciej Hildebrand

Dr. Maciej Hildebrand

orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2014 in Journal of Civil Structural Health Monitoring
Verified
Journal Article
Open access
PDF file
CMCzesław Machelski
Czesław Machelski
MHMaciej Hildebrand
Maciej Hildebrand
The cable-stayed bridge over the Vistula River in Plock, Poland, contains the longest span among Polish bridges, i.e., 375 m. The bridge was therefore equipped with monitoring system consisting of 25 sensors. They are: eight sensors of force in selected stays, two inclinometers located on the tops of pylons, ten strain gauges located on the steel structural members, three temperature sensors located inside the main span, two anemometers. The results obtained from the system, which works since the year 2005, were analyzed in terms of sensitivity of the structure as well the sensitivity of the monitoring system to the actions or loads imposed to the structure. The analysis of loads affecting stay forces is presented. Moreover, the analysis of piers’ settlement influence on force distribution in stays is given. Several topics of comments are added. The analyses are performed to answer the question if it is possible to identify the selected phenomena of behavior of the bridge based on the records from a simple monitoring system.

10 June 2025 in Sensors
Verified
Journal Article
Open access
PDF file
CMCzesław Machelski
Czesław Machelski
MHMaciej Hildebrand
Maciej Hildebrand
Jarosław RybakJarosław Rybak
Jarosław Rybak
Long-term processes, manifesting themselves in slow geometrical alterations and changes in internal forces, have been known and observed to take place mainly in large bridges made of prestressed concrete, but they also occur, albeit to a smaller degree, in steel bridges. Two sets of data, coming from, respectively, multi-year geodetic surveys and the structural health monitoring of a cable-stayed bridge (forces in its stays), were compared. Using the collocation method, displacements consistent with the results of the geodetic measurements were input into a numerical model of the bridge. Then, changes in the forces in the stays, which should accompany the displacements, were computed. The computed changes were compared with the actual changes in the mean force values in the stays of the bridge recorded over an eight-year period of its structural health monitoring. The two sets of data were found to be not in satisfactory good agreement. The main factors making it difficult to reach full agreement were the very small relative values of the observed geometrical alterations (the deformation, i.e., the increase in deflection, of the 375 m long span amounting merely 10–15 mm after eight years of periodic measurement) and the very small changes (amounting to about 0.5% for 8 years of monitoring) in the mean forces in the stays, as well as the possible mistakes in the survey. Despite these difficulties, the employed collocation method proved to be effective. It was also found that the long-term geometrical alterations and the changes in the forces in the stays do not adversely affect the safety of the bridge and its use.

28 September 2020 in The Baltic Journal of Road and Bridge Engineering
Verified
Journal Article
Open access
PDF file
MHMaciej Hildebrand
Maciej Hildebrand
ŁNŁukasz Nowak
Łukasz Nowak
Uneven temperature distribution in a structural element constitutes one of its load factors. Temperature fields occurring in structural elements lead to stresses and strains. The values of internal stresses are directly related to temperature distribution and degree of freedom for element deformation. The best way to get information about temperature distribution in an element is to take measurements on a real object. Such measurements have been run or are still taken over decades in various parts of the world, e.g. in Western Europe, USA, China, South America. In a number of cases, such examinations were carried out for objects constructed in warm or hot climate. It is a lot harder to find the results of measurements made in the countries with moderate and transitional climate, like in the Central or East-Central Europe. This paper presents measurement methodology and results gained for a large steel bridge located in the East European Plain, about 52.5° N northern latitude. Permanently installed contact sensors, temporary sensors, as well as pyrometry and thermography were used. An attempt was made to determine temperature distribution in a steel box girder of a bridge using thermovision technique. Approximate temperature distribution patterns in the main span girder were determined from thermal photographs taken. The most important results of examinations are the images of temperature fields in the main span girder related to solar radiation that first and foremost directly affects the bridge deck.

25 March 2024 in The Baltic Journal of Road and Bridge Engineering
Verified
Journal Article
Open access
PDF file
CMCzesław Machelski
Czesław Machelski
MHMaciej Hildebrand
Maciej Hildebrand
MKMaksymilian Kliński
Maksymilian Kliński
The measurement of bridge deflection induced by a motor vehicle is an effective way of verifying the weight of the vehicle, and even of determining the layout of its axles. If the vehicle’s weight and the impacts of its individual axles are known, deflection measurements can be used to verify the stiffness of the bridge structure and to evaluate the effectiveness of steel-concrete composite span integration. The bridge in this case study had been specially permanently adapted to carrying very heavy loads, generated by overweight transports reaching the total weight of a few to over 10 MN. The results of measurements of span deflections induced by a heavy vehicle and the way they were used to assess the weight of another overweight transport unit crossing the bridge are presented in the paper. The existing strengthening of the bridge has been found to be universal and effective for various overweight transports.

1 October 2017 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
MHMaciej Hildebrand
Maciej Hildebrand
Jarosław RybakJarosław Rybak
Jarosław Rybak
Structures made of reinforced soil can be evaluated for their safety based on a load testing. Measurement results are essentially evaluated by displacements of surcharge (mainly in vertical direction) and facing elements (mainly in horizontal direction). Displacements are within several tenths to several millimetres and they can be taken by common geodetic equipment. Due to slow soil consolidation (progress of displacements) under constant load, observations should be made over several days or even weeks or months. A standard procedure of heating of geotextiles, used in laboratory conditions to simulate long term behaviour cannot be used in a natural scale. When the load is removed, the soil unloading occurs. Both the progress of displacements and soil unloading after unloading of the structure are the key presumptions for evaluating its safety (stability). Assessment of measuring results must be preceded by assuming even the simplest model of the structure, so as it could be possible to estimate the expected displacements under controlled load. In view of clearly random nature of soil parameters of retaining structure composed of reinforced soil and due to specific erection technology of reinforced soil structure, the assessment of its condition is largely based on expert's judgment. It is an essential and difficult task to interpret very small displacements which are often enough disturbed by numerous factors like temperature, insolation, precipitation, vehicles, etc. In the presented paper, the authors tried to establish and juxtapose some criteria for a load test of a bridge abutment and evaluate their suitability for decision making. Final remarks are based on authors experience from a real full scale load test.

31 August 2023 in Inżynieria i Budownictwo
Verified
Journal Article
Closed access
JBJan Biliszczuk
Jan Biliszczuk
MHMaciej Hildebrand
Maciej Hildebrand
KJKrystyna Januszkiewicz
Krystyna Januszkiewicz
MTMarco Teichgraeber
Marco Teichgraeber