Recently, deep learning (DL) models, especially those based on long short-term memory (LSTM), have demonstrated their superior ability in resolving sequential data problems. This study investigated the performance of six models that belong to the supervised learning category to evaluate the performance of DL models in terms of streamflow forecasting. They include a feed-forward neural network (FFNN), a convolutional neural network (CNN), and four LSTM-based models. Two standard models with just one hidden layer-LSTM and gated recurrent unit (GRU)-are used against two more complex models-the stacked LSTM (StackedLSTM) model and the Bidirectional LSTM (BiLSTM) model. The Red River basin-the largest river basin in the north of Vietnam-was adopted as a case study because of its geographic relevance since Hanoi city-the capital of Vietnam-is located downstream of the Red River. Besides, the input data of these models are the observed data at seven hydrological stations on the three main river branches of the Red River system. This study indicates that the four LSTM-based models exhibited considerably better performance and maintained stability than the FFNN and CNN models. However, the complexity of the StackedLSTM and BiLSTM models is not accompanied by performance improvement because the results of the comparison illustrate that their respective performance is not higher than the two standard models-LSTM and GRU. The findings of this study present that LSTM-based models can reach impressive forecasts even in the presence of upstream dams and reservoirs. For the streamflow-forecasting problem, the LSTM and GRU models with a simple architecture (one hidden layer) are sufficient to produce highly reliable forecasts while minimizing the computation time.

Precipitation is a crucial component of the water cycle and plays a key role in hydrological processes. Recently, satellite-based precipitation products (SPPs) have provided grid-based precipitation with spatiotemporal variability. However, SPPs contain a lot of uncertainty in estimated precipitation, and the spatial resolution of these products is still relatively coarse. To overcome these limitations, this study aims to generate new grid-based daily precipitation based on a combination of rainfall observation data with multiple SPPs for the period of 2003–2017 across South Korea. A Random Forest (RF) machine-learning algorithm model was applied for producing a new merged precipitation product. In addition, several statistical linear merging methods have been adopted to compare with the results achieved from the RF model. To investigate the efficiency of RF, rainfall data from 64 observed Automated Synoptic Observation System (ASOS) installations were collected to analyze the accuracy of products through several continuous as well as categorical indicators. The new precipitation values produced by the merging procedure generally not only report higher accuracy than a single satellite rainfall product but also indicate that RF is more effective than the statistical merging method. Thus, the achievements from this study point out that the RF model might be applied for merging multiple satellite precipitation products, especially in sparse region areas.

Calculating rainfall erosivity, which is the capacity of rainfall to dislodge soil particles and cause erosion, requires the measurement of the rainfall kinetic energy (KE). Direct measurement of KE has its own challenges, owing to the high cost and complexity of the measuring instruments involved. Consequently, the KE is often approximated using empirical equations derived from rainfall intensity (I_r) inputs in the absence of such instruments. However, the KE–I_r equations strongly depend on local climate patterns and measurement methods. Therefore, this study aims to compare and evaluate the efficacy of 27 KE–I_r equations with observed data. Based on a re-analysis, we also propose an exponential KE–I_r equation for the entire Korean site, and the spatial distribution of its parameter in the equation is also discussed. In this investigation, we used an optical disdrometer (OTT Parsivel²) to gather data in Sangju City (Korea) between June 2020 and December 2021. The outputs of this study are shown as follows: (1) The statistically most accurate estimates of KE expenditure and KE content in Sangju City are obtained using power-law equations given by Sanchez-Moreno et al. and exponential equations published by Lee and Won, respectively. (2) The suggested KE–I_r equation applied to the entire Korean site exhibits a comparable general correlation with the observed data. The parameter maps indicate a high variance in geography.

Estimation of sediment transport capacity (STC) plays a crucial role in simulating soil erosion using any physics-based models. In this research, we aim to investigate the pros and cons of six popular STC methods (namely, Shear velocity, Kilinc-Richardson (KR), Effective stream power, Slope and unit discharge, Englund-Hansen (EH), and Unit stream power) for soil erosion/deposition simulation at watershed scales. An in-depth analysis was performed using the selected STC methods integrated into the Grid Surface Subsurface Hydrologic Analysis model for investigating the changes in morphology at spatial-temporal scales at the Cheoncheon watershed, South Korea, over three storm events. Conclusions were drawn as follows. (1) Due to the ability of the KR and EH methods to include an additional parameter (i.e., erodibility coefficient), they outperformed others by producing more accurate simulation results of sediment concentration predictions. The KR method also proved to be superior to the EH method when it showed a more suitable for sediment concentration simulations with a wide range of sediment size and forcing magnitude. (2) We further selected 2 STC methods among the 6 methods to deeply explore the spatial distribution of erosion/deposition. The overall results were more agreeable. For instance, the phenomenon of erosion mainly occurred upstream of watersheds with steep slopes and unbalanced initial sediment concentrations, whereas deposition typically appeared at locations with flat terrain (or along the mainstream). The EH method demonstrated the influence of topography (e.g., gradient slope) on accretionary erosion/deposition results more significantly than the KR method. The obtained results contribute a new understanding of rainfall-sediment-runoff processes and provide fundamental plans for soil conservation in watersheds.

In Korea, approximately 70% of the country is mountainous, with steep slopes and heavy rainfall in summer from June to September. Korea is classified as a high-risk country for soil erosion, and the rate of soil erosion is rapidly increasing. In particular, the operation of Doam dam was suspended in 2001 because of water quality issues due to severe soil erosion from the upstream areas. In spite of serious dam sediment problems in this basin, in-depth studies on the origin of sedimentation using physic-based models have not been conducted. This study aims to analyze the spatial distribution of net erosion during typhoon events using a spatially distributed physics-based erosion model and to improve the model based on a field survey. The spatially uniform erodibility constants of the surface flow detachment equation in the original erosion model were replaced by land use erodibility constants based on benchmarking experimental values to reflect the effect of land use on net erosion. The results of the upgraded model considering spatial erodibility show a significant increase in soil erosion in crop fields and bare land, unlike the simulation results before model improvement. The total erosion and deposition for Typhoon Maemi in 2003 were 36,689.0 and 9893.3 m³, respectively, while the total erosion and deposition for Typhoon Rusa in 2002 were 142,476.6 and 44,806.8 m³, respectively, despite about twice as much rainfall and 1.2 times as high rainfall intensity. However, there is a limitation in quantifying the sources of erosion in the study watershed, since direct comparison of the simulated net erosion with observed spatial information from aerial images, etc., is impossible due to nonperiodic image photographing. Therefore, continuous monitoring of not only sediment yield but also periodic spatial detection on erosion and deposition is critical for reducing data uncertainty and improving simulation accuracy.