Olga Smerdova

Prof. Olga Smerdova

Institut Pprime, ISAE-ENSMA

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2017 in Composites Part A: Applied Science and Manufacturing
Verified
Journal Article
Open access
DMDaniel M. Mulvihill
Daniel M. Mulvihill
OSOlga Smerdova
Olga Smerdova
MSMichael P.F. Sutcliffe
Michael P.F. Sutcliffe
The fundamental frictional behaviour of carbon fibre tows relevant to composite fabric forming is explored. Tow-on-tool and tow-on-tow contact are considered. For tow-on-tool contact, an experiment is devised to simultaneously observe the true filament contact length and measure the friction force over a range of normal loads. Filament contact length is not constant, as would be given from an idealised assumption of parallel touching filaments, but increases in a characteristic manner with normal load. Friction force follows a power law variation with normal load with exponent in the range 0.7–1. Accounting for the evolving contact length in a Hertzian calculation of the real contact area produces a contact area versus load variation which differs only by a constant factor from the measured friction force curves. Thus, the results agree with a ‘constant interface strength’ model of friction. Tow orientation and sizing are found to have a significant effect on friction by altering the real contact area

15 March 2024 in International Journal of Plasticity
Verified
Journal Article
Open access
SHS. Hémery
S. Hémery
ANazdine nait-ali
azdine nait-ali
OSOlga Smerdova
Olga Smerdova
CTC. Tromas
C. Tromas

1 June 2015 in Composites Part A: Applied Science and Manufacturing
Verified
Journal Article
Open access
OSOlga Smerdova
Olga Smerdova
MSMichael P.F. Sutcliffe
Michael P.F. Sutcliffe
This paper provides measurements and analysis at the meso and microscopic scales of the real contact area between twill carbon fabric and a flat glass counterface. The mesoscopic contact area associated with tow contacts is about 55–75% of the nominal area. However, the total real contact length within the tow contacts, associated with microscopic contact at the fibre level, is only 4–8% of the idealised contact conditions with parallel touching fibres, for a nominal contact pressure of around 2kPa. The dependence of real contact area on fabric shear angle is also investigated. The estimated real contact pressure is 15,000 times higher than the nominal contact pressure. Models or experiments of friction in composites forming which do not take into account the real contact situation, which is very far from an idealised packing arrangement, may fail to capture the essential tribological mechanisms

14 October 2019 in Journal of Materials Research
Verified
Journal Article
Closed access
PDF file
OSOlga Smerdova
Olga Smerdova
MPMarina Pecora
Marina Pecora
MGMarco Gigliotti
Marco Gigliotti

1 September 2014 in Tribology International
Verified
Journal Article
Closed access
OSOlga Smerdova
Olga Smerdova
DMDenis Mazuyer
Denis Mazuyer
JCJuliette Cayer-Barrioz
Juliette Cayer-Barrioz

3 June 2015 in Experimental Mechanics
Verified
Journal Article
Open access
PDF file
OSOlga Smerdova
Olga Smerdova
MSMichael Sutcliffe
Michael Sutcliffe
This paper describes a novel experimental rig and associated experimental method developed to investigate composite fabric/tool contact at the microscopic scale. A key feature of this method is that it enables direct observation of real contact at the scale of fibres and the evolution of this contact under simultaneous application of shear and compression loads. To observe the contact, an optical semi-reflective coating is used. An algorithm is developed to analyse the contact images and measure the real contact length and orientation of individual fibres. The method is applied to microcontacts of carbon twill fabric. The real contact length under an apparent pressure of 1.9 kPa is surprisingly small compared to the apparent contact length. Transverse forces associated with friction are also measured. However these results are difficult to interpret as the test generates friction forces which differ from those which would be seen in conventional sliding friction tests.