One-dimensional strongly nonlinear phononic crystals were assembled from chains of PTFE (polytetrafluoroethylene) and stainless-steel spheres with gauges installed inside the beads. Trains of strongly nonlinear solitary waves were excited by impacts. A significant modification of the signal shape and an increase of solitary wave speed up to two times (at the same magnitude of dynamic contact force) were achieved through a noncontact magnetically induced precompression of the chains. The data for the PTFE based chains are presented for the first time and the data for the stainless-steel beads chains are extended into a range of maximum dynamic forces more than one order of magnitude lower than previously reported. Experimental results agreed reasonably well with the long-wave approximation and numerical calculations based on the Hertz interaction law for particles interactions.
Granular materials exhibit a strongly nonlinear behavior affecting the propagation of energy and information. Dynamically self-organized strongly nonlinear solitary waves are the main information carriers in granular chains. We report the first experimental observation of the dramatic change of solitary wave reflectivity from the interface of two granular media triggered by a magnetically induced precompression. It may be appropriate to name this phenomenon the “acoustic diode” effect. We explain this effect by the high gradient of particle velocity near the interface.
We report the first experimental observation of impulse confinement and the disintegration of shock and solitary waves in one-dimensional strongly nonlinear composite granular materials. The chains consist of alternating ensembles of beads with high and low elastic moduli (more than 2 orders of magnitude difference) of different masses. The trapped energy is contained within the “softer” sections of the composite chain and is slowly released in the form of weak, separated pulses over an extended period of time. This effect is enhanced by using a specific group assembly and precompression.
One-dimensional “sonic vacuum” type phononic crystals were assembled from a chain of polytetrafluoroethylene (PTFE,Teflon) spheres with different diameters in a Teflon holder. It was demonstrated that this polymer-based sonic vacuum, with exceptionally low elastic modulus of particles, supports propagation of strongly nonlinear solitary waves with a very low speed. These solitary waves can be described using the classical nonlinear Hertz law despite the viscoelastic nature of the polymer and high strain rate deformation of the contact area. The experimentally measured speeds of solitary waves at high amplitudes are close to the theoretically estimated values with a Young’s modulus of obtained from shock wave experiments. This is significantly higher than the Young’s modulus of PTFE from ultrasonic measurements. Trains of strongly nonlinear solitary waves excited by an impact were investigated experimentally and were found to be in reasonable agreement with numerical calculations based on Hertz interaction law though exhibiting a significant dissipation.
One-dimensional nonlinear phononic crystals have been assembled from periodic diatomic chains of stainless steel cylinders alternated with Polytetrafluoroethylene spheres. This system allows dramatic changes of behavior (from linear to strongly nonlinear) by application of compressive forces practically without changes of geometry of the system. The relevance of classical acoustic band-gap, characteristic for chain with linear interaction forces and derived from the dispersion relation of the linearized system, on the transformation of single and multiple pulses in linear, nonlinear and strongly nonlinear regimes are investigated with numerical calculations and experiments. The limiting frequencies of the acoustic band-gap for investigated system with given precompression force are within the audible frequency range (20–20,000 Hz) and can be tuned by varying the particle’s material properties, mass and initial compression. In the linear elastic chain the presence of the acoustic band-gap was apparent through fast transformation of incoming pulses within very short distances from the chain entrance. It is interesting that pulses with relatively large amplitude (nonlinear elastic chain) exhibit qualitatively similar behavior indicating relevance of the acoustic band gap also for transformation of nonlinear signals. The effects of an in situ band-gap created by a mean dynamic compression are observed in the strongly nonlinear wave regime.
The variation of metallic particle size and sample porosity significantly alters the dynamic mechanical properties of high density granular composite materials processed using a cold isostatically pressed mixture of polytetrafluoroethylene (PTFE), aluminum (Al), and tungsten (W) powders. Quasistatic and dynamic experiments are performed with identical constituent mass fractions with variations in the size of the W particles and pressing conditions. The relatively weak polymer matrix allows the strength and fracture modes of this material to be governed by the granular type behavior of agglomerated metal particles. A higher ultimate compressive strength was observed in relatively high porosity samples with small W particles compared to those with coarse W particles in all experiments. Mesoscale granular force chains of the metallic particles explain this unusual phenomenon as observed in hydrocode simulations of a drop-weight test. Macrocracks forming below the critical failure strain for the matrix and unusual behavior due to a competition between densification and fracture in dynamic tests of porous samples were also observed. Numerical modeling of shock loading of this granular composite material demonstrated that the internal energy, specifically thermal energy, of the soft PTFE matrix can be tailored by the W particle size distribution.