Platinum (Pt) supported on transition metal carbide (TMC) surfaces (Pt/TMC) has been the focus of significant research interest, due to the similar electronic and geometric structures between TMC and Pt. This paper focuses on a new type of electrocatalyst fabrication using high purity β-molybdenum carbide (referred to as Mo2C hereafter) nanotubes as a support and atomic layer deposition (ALD) as the Pt nanoparticle deposition technique (Pt/Mo2C). In particular, rotary ALD equipment was used to grow Pt particles from the subnanometer level to 2 to 3 nanometers by simply adjusting the number of ALD cycles in order to probe the interaction between the deposited Pt nanoparticles and Mo2C nanotube support. Lattice spacing analysis using high resolution transmission electron microscopy (HRTEM) images, combined with Pt binding energy shift in XPS results, clearly showed a strong interaction between Pt nanoparticles and the Mo2C nanotube support in all the resultant Pt/Mo2C samples. We postulate that this strong interaction is responsible for the significantly enhanced durability observed in constant potential electrolysis (CPE) testing. Of the three samples from different ALD cycles (15, 50 and 100), Mo2C nanotubes modified by 50 (1.07 wt% Pt loading) and 100 cycles (4.4 wt% Pt) of Pt deposition showed higher activity per Pt mass than commercial 20% Pt supported on carbon black. Finally, we report the nanoscale Pt/Mo2C catalyst performance in a device setting for different Pt loadings by applying it in a PEMFC anode.
28 July 2021 in ACS Applied Materials & Interfaces
By incorporating a parallel wire collector in electrospinning process with a hot-drawing treatment, carbon fiber mats with well-aligned coal-derived carbon nanofibers (CCNFs) were successfully fabricated. It was previously reported that the well-aligned fiber orientation could facilitate the mass transfer of electrolyte ion. In this paper, we demonstrate that surface oxygen concentration, pore area/volume and electrical conductivity were also significantly enhanced by the well-aligned carbon fiber, compared the randomly aligned CCNFs. Consequently, the well-aligned CCNFs generated the areal specific capacitance of 1590 mF cm−2 at the current density of 4 mA cm−2 in 6M KOH solution, which outperformed the aligned carbon nanofibers derived from adding carbon nanotubes or graphene as fillers into polymer precursors. Finally, a carbon/carbon supercapacitor cell was assembled with the well-aligned CCNFs mats as electrodes, showing the areal energy density of 15 μWh cm−2 at the power density of 0.3 mW cm−2, as well as gravimetric energy density of 30 Wh kg−1 at the power density of 0.6 kW kg−1 and the volumetric energy density of 18.2 mWh cm−3 at the scan rate of 50 mV s−1. 88.6% specific capacitance of full cell was retained after 5000 cycles of charge-discharge running at current density of 1 A g−1.