Solvent-free microwave extraction (SFME) and conventional hydro-distillation (HD) were used for the extraction of essential oils (EOs) from Egyptian sweet basil (Ocimum basilicum L.) leaves. The two resulting EOs were compared with regards to their chemical composition, antioxidant, and antimicrobial activities. The EO analyzed by GC and GC-MS, presented 65 compounds constituting 99.3% and 99.0% of the total oils obtained by SFME and HD, respectively. The main components of both oils were linalool (43.5% SFME; 48.4% HD), followed by methyl chavicol (13.3% SFME; 14.3% HD) and 1,8-cineole (6.8% SFME; 7.3% HD). Their antioxidant activity were studied with the 2,2-diphenyl-1-picrylhydrazyl (DPPH•) radical scavenging method. The heating conditions effect was evaluated by the determination of the Total Polar Materials (TPM) content. The antimicrobial activity was investigated against five microorganisms: two Gram-positive bacteria, Staphylococcus aureus and Bacillus subtilis, two Gram-negative bacteria, Escherichia coli and Pseudomonas aeruginosa, and one yeast, Candida albicans. Both EOs showed high antimicrobial, but weak antioxidant, activities. The results indicated that the SFME method may be a better alternative for the extraction of EO from O. basilicum since it could be considered as providing a richer source of natural antioxidants, as well as strong antimicrobial agents for food preservation.
15 June 2011 in European Journal of Organic Chemistry
This paper focuses on the use of natural sources for the preparation of efficient and low cost catalysts. CaCO3 is obtained from cuttlefish bone and was modified by the cation exchange of Ca2+ by Cu2+ in CaCO3 using solutions of copper (Cu(NO3)2) at different concentrations. The modification of the solids was investigated using X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), energy dispersive spectrometry (EDS) and ultraviolet-visible (UV-vis) spectroscopy. The results show that the copper exchanged materials contain a CuCO3–CuO nanoparticle composite. The obtained solids were used as catalysts for the cycloaddition reaction of different azides with activated alkenes at room temperature under liquid phase conditions. The different parameters which affect the reaction were investigated such as reaction time, temperature of the reaction, effect of the copper content, catalyst mass, effect of the solvent and nature of the azide. High yields were obtained when the catalyst contained more copper. The best catalysts were calcined at different temperatures (200, 300, 400, 500 °C) in order to determine whether the active phase was CuCO3 or CuO in the catalytic reaction. The XRD analysis of the calcined composites shows that an increase in calcination temperature leads to the formation of the CuO phase. On the other hand, the use of these calcined materials as catalysts shows that the active phase is copper carbonate. Finally, a new method for preparing triazoles with short reaction times was developed by the use of a cheap environmentally friendly catalyst.
1 February 2006 in Journal of Molecular Structure: THEOCHEM