Shake-table tests of a 3-story reinforced concrete building with cladding casted to be monolithic with frame elements, with seismic slits or cut reinforcing bars present in some cladding elements to ensure a desirable deformation mechanism, was performed at E-Defense to evaluate its post-disaster functionality. The building satisfied response objectives; behaving elastically with 0.33% drift or less during a “severe earthquake motion” defined in the Japanese Building Standard Law, and has a base shear capacity coefficient greater than 0.55. However, the damage was greater than expected due to deformations concentrating on a few cracks, resulting in continuous functionality not necessarily being achieved.

Evaluating the performance of reinforced concrete (RC) structures during earthquakes and the resultant damage in the structures depends on an accurate load–displacement relationship. Several experimental and analytical evaluation methods for load–displacement relationships have been proposed and specified in current design standards. However, there have been few quantitative studies on the impact of drying on the yielding behavior of RC members, including evaluations of the effective stiffness of members. In this study, to investigate changes in the mechanical properties of RC beam–slab members due to drying of the concrete, cyclic loading tests are conducted on two RC beam–slab members with and without drying. It is found that the lateral structural stiffness of the specimen with drying decreased to 77% that of the specimen without drying. This is verified in the calculation of the flexural stiffness. In this calculation, it is assumed that drying shrinkage decreases the moment of inertia of the slab in tension but not in compression. Meanwhile, no difference is observed in the flexural capacity and yield displacement between the two specimens. Thus, there is no significant impact from drying shrinkage in RC beam–slab members on the lateral structural performance, while the shrinkage instead induces greater flexural cracking, which reduces the residual stresses in the specimen with drift leading to a gradual decrease in the impact of drying.

The required base shear and drift limit for post-disaster management buildings have increased in the Japanese Building Code following major seismic events. One method to satisfy these requirements for reinforced concrete frame buildings is to cast exterior non-structural concrete wall elements to be monolithic with frame elements, but without anchoring the longitudinal wall reinforcing. This provides additional stiffness and strength while limiting significant damage in the non-structural wall. In this study, the structural performances of such elements were evaluated using static and dynamic experimental tests. The result indicates that non-structural walls that were neither isolated by seismic slits nor anchored to the adjacent walls with longitudinal reinforcements experienced less damage and higher deformability compared with walls having seismic slits. The confinement reinforcing impact was not observed on the strength and drift capacity of the beam member, owing to the large number of transverse reinforcements. However, the confinements limited the damage and nearly prevented concrete crushing. The maximum horizontal load of the specimen could be predicted using cross-sectional analysis, and the authors propose a simple equation to predict it with sufficient accuracy.