Bed level dynamics at the interface of the salt marsh and tidal flat have been highlighted as a key factor connecting the long‐term biogeomorphological development of the marsh to large‐scale physical forcing. Hence, we aim to obtain insight into the factors confining the location of the marsh edge (i.e., boundary between tidal flat and salt marsh). A unique data set was collected, containing measurements of daily bed level changes (i.e., integrative result of physical forcing and sediment properties) at six intertidal transects in the North Sea area. Moreover, various biophysical parameters were measured, such as sediment characteristics, waves, inundation time, and chlorophyll‐a levels. The data show that both bed level change and waves decreased from the lower intertidal flat toward the marsh edge and further diminished inside the marsh. However, no direct general relation was found between waves and bed level change. Bed level change inside the marsh was always small, regardless of wave energy. By combining the data sets, we demonstrate that the location of the lower marsh edge is restricted by two interacting factors: inundation time and bed level change. For vegetation establishment to withstand longer inundation stress, which slows down plant growth, more stable bed levels are required so that plants are not heavily disturbed. Conversely, to withstand more dynamic bed levels that disturbs plant growth, lower inundation stress is needed, so that plants grow fast enough to recover from the stress. The results suggest that bed level change is important in determining the position of the marsh edge.
5 June 2021 in Earth Surface Processes and Landforms
The vulnerability of saltmarshes to lateral erosion at their margin depends on the local biogeomorphological properties of the substrate. In particular, the 3D architecture of pore and root systems is expected to influence shear strength, with repercussions for the wider‐scale stability of saltmarshes. We apply X‐ray computed microtomography (μCT) to visualize and quantify subsurface structures in two UK saltmarshes at Tillingham Farm, Essex (silt/clay rich substrate) and Warton Sands (sand‐rich substrate), with four types of ground cover: bare ground, Spartina spp, Salicornia spp and Puccinellia spp. We extracted μCT structural parameters that characterize pore and root morphologies at each station, and compared them with field measurements of shear strength using a principal component analysis and correlation tests. The 3D volumes show that species‐dependent variations in root structures, plant colonization events and bioturbation activity control the morphology of macropores, while sediment cohesivity determines the structural stability and persistence of these pore structures over time, even after the vegetation has died. Areas of high porosity and high mean pore thickness were correlated to lower values of shear strength, especially at Tillingham Farm, where well‐connected vertical systems of macropores were associated with current or previous colonization by Spartina spp. However, while well‐connected systems of macropores may lower the local deformation threshold of the sediment, they also encourage drainage, promote vegetation growth and reduce the marsh vulnerability to hydrodynamic forces. The highest values of shear strength at both sites were found under Puccinellia spp, and were associated with a high density of mesh‐like root structures that bind the sediment and resist deformation. Future studies of marsh stability should ideally consider time series of vegetation cover, especially in silt/clay‐dominated saltmarshes, in order to consider the potential effect of preserved buried networks of macropores on water circulation, marsh functioning and cliff‐face erosion.
1 February 2022 in Estuarine, Coastal and Shelf Science