This work presents the synthesis of Au nanoparticles from gold coatings recovered from processor pins with minimal waste generation. The process consisted of four main steps: (1) physical recovery of pins, (2) recovery of gold coatings by acid digestion, (3) synthesis of HAuCl4 under mild conditions and, (4) synthesis of Au nanoparticles by the Turkevich method. The small dimensions of Au coatings allowed the synthesis of HAuCl4 with lower amounts of HClconc and HNO3conc than those used with aqua regia. This method has significant advantages, such as lower NO2(g) emission, easy post-treatment and purification, low synthesis cost and high yields. Gold nanoparticles synthesized from HAuCl4 were characterized by transmission electron microscopy (TEM) and UV-Vis spectroscopy. Size distribution analysis showed particles 14.23 nm in length and 12.05 nm in width, while absorption spectra showed a surface plasmon located at 523 nm; these characteristics were very similar to those observed with Au nanoparticles obtained with Aldrich’s reagent. It is suggested that recycling procedures can be improved by taking into account the size and shape of the metals to be recovered, thus introducing a new field of research known as hydronanometallurgy.
This study investigates the potential of using gold nanoparticles (Au NPs) synthesized from e-waste as electrocatalysts for the methanol oxidation reaction (MOR), with the aim of applying them as an anode in alkaline direct methanol fuel cells (ADMFCs). The research addresses the pressing environmental challenge of e-waste disposal and explores the recycling of e-waste to obtain valuable materials for sustainable applications. Vulcan-supported gold nanoparticles (Aue-w/C NPs) are synthesized from gold coatings recovered from Intel Pentium 4 processor pins, demonstrating the feasibility of e-waste as electrocatalyst precursors. Comprehensive characterization techniques such as UV-Vis spectroscopy, high-resolution transmission and transmission electron microscopy (HR-TEM, TEM), selected area electron diffraction (SAED), scanning electron microscopy (SEM), and X-ray diffraction (XRD) are employed to evaluate the structural properties of the electrocatalyst. Electrochemical evaluation in 0.5 M KOH electrolyte by cyclic voltammetry reveals that the synthesized Aue-w/C NPs exhibit electrocatalytic activity (25.5 mA·mg−1Au) comparable to their commercially synthesized counterparts (30.1 mA·mg−1Au). This study highlights the potential for sustainable approaches in the production of electrocatalysts by utilizing e-waste as a source of valuable catalyst materials. It represents a pioneering effort in harnessing e-waste as a sustainable resource, offering new avenues for sustainable energy technologies while addressing environmental concerns and technological challenges in the field of ADMFCs.
In this work, the oxygen reduction reaction in the absence or presence of 2.0 mol l−1methanol and the hydrogen oxidation reaction are studied on RuFe electrocatalyst synthesized by a microwave thermal heating method in water as reaction medium. The electrocatalysts were morphologically and structurally typified by scanning electron microscopy and by x-ray diffraction, respectively. Three crystalline phases were found: Ru, Fe2O3and Fe(OH)3·(H2O)x(Bernalite). Functional tests were performed by convective (rotating disk electrode) and non-convective (linear sweep voltammetry and cyclic voltammetry) electrochemical techniques in 0.5 mol l−1H2SO4. Both RuFe electrocatalysts show interesting electrochemical activities since they can carry out both the oxygen reduction reaction and the hydrogen oxidation reaction.
Metallic ruthenium electrocatalyst with activity for the hydrogen oxidation reaction and the oxygen reduction reaction has been synthesized by microwave irradiation at 180 ℃ in deionized water as reaction media. Characterization of the material by ATR-FTIR spectroscopy shows a complete decarbonylation of the precursor Ru3(CO)12 with formation of metallic Ru, which is confirmed by the corresponding x-ray diffraction analysis. Evaluation of the material's electrocatalytic properties by the rotating disk electrode technique in 0.5 mol L-1 allows the study of hydrogen oxidation and oxygen reduction reaction using linear sweep voltammetry, exhibiting that the diffusional processes of H2 and O2 can be improved by modifying the electrocatalytic ink preparation.