Ambarish Kulkarni

Mr. Ambarish Kulkarni

RWTH Aachen University, Aachen, North Rhine-Westphalia, Germany
+1
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2021 in Computational Materials Science
Verified
Journal Article
Closed access
SPSandeep P. Patil
Sandeep P. Patil
AKAmbarish Kulkarni
Ambarish Kulkarni
BMBernd Markert
Bernd Markert

Verified
Journal Article
Open access
PDF file
Sandeep P. PatilSandeep P. Patil
Sandeep P. Patil
AKAmbarish Kulkarni
Ambarish Kulkarni
Bernd MarkertBernd Markert
Bernd Markert
We propose a molecular-based three-dimensional (3D) continuum model of dragline silk of Araneus diadematus, which takes into account the plasticity of the β-sheet crystals, the rate-dependent behavior of the amorphous matrix, and the viscous interface friction between them. For the proposed model, we computed the tensile properties, the effects of velocity on the mechanical properties, and hysteresis values, which are in good agreement with available experimental data. The silk fiber model’s yield point, breaking strength, post-yield stiffness, and toughness increased with increasing pulling velocity, while extensibility and the diameter of the silk fiber decreased. Our bottom-up approach has shed light on silk fiber mechanics, which can be used as an essential tool to design artificial composite materials.

9 April 2021 in Metals
Verified
Journal Article
Open access
PDF file
AKAmbarish Kulkarni
Ambarish Kulkarni
VKVispi Karkaria
Vispi Karkaria
MNMilankumar Nandgaonkar
Milankumar Nandgaonkar
Sandeep P. PatilSandeep P. Patil
Sandeep P. Patil
Bernd MarkertBernd Markert
Bernd Markert
The high-speed forming process is the key to attaining difficult and irregular profiles on ductile materials. In the present work, we proposed the all-atom model of the gas detonation forming process, wherein molecular dynamics (MD) simulations were performed on the aluminum workpiece at different loading speeds similar to the various pressure values in the process. The deformation response of an aluminum workpiece for a wide range of loading speeds, 0.1–8 Å/ps, was investigated. The dome-height, failure patterns, and formability of the aluminum workpiece were examined for these loading speeds. We obtained an inverse relationship between the formability of the aluminum workpiece and the applied loading speed. Moreover, in this work, the influence of the different percentage of defects in the workpieces on the mechanical behavior was investigated. We observed that at lower speeds (< 2 Å/ps), the deformation is observed throughout the workpiece starting from the point of contact in the middle and that is contrary to the deformations observed due to the higher loading speed where localized deformations occur due to creation of slipping planes. We also found that the internal voids lead to the rearrangement of atoms to facilitate the movement of slipping planes leading to better formability compared to the no-void workpieces. This work helps to get a fundamental understanding of deformation behavior in the high-speed forming process with and without defects in the aluminum workpiece at the nanoscale.