Herbs and spices have been used since antiquity for their nutritional and health properties, as well as in traditional remedies for the prevention and treatment of many diseases. Therefore, this study aims to perform a chemical analysis of both essential oils (EOs) from the seeds of Carum carvi (C. carvi) and Coriandrum sativum (C. sativum) and evaluate their antioxidant, antimicrobial, anti-acetylcholinesterase, and antidiabetic activities alone and in combination. Results showed that the EOs mainly constitute monoterpenes with γ-terpinene (31.03%), β-pinene (18.77%), p-cymene (17.16%), and carvone (12.20%) being the major components present in C. carvi EO and linalool (76.41%), γ-terpinene (5.35%), and α-pinene (4.44%) in C. sativum EO. In comparison to standards, statistical analysis revealed that C. carvi EO showed high and significantly different (p < 0.05) antioxidant activity than C. sativum EO, but lower than the mixture. Moreover, the mixture exhibited two-times greater ferric ion reducing antioxidant power (FRAP) (IC₅₀ = 11.33 ± 1.53 mg/mL) and equipotent chelating power (IC₅₀ = 31.33 ± 0.47 mg/mL) than the corresponding references, and also potent activity against 2,2-diphenyl-1-picrylhydrazyl (DPPH) (IC₅₀ = 19.00 ± 1.00 mg/mL), β-carotene (IC₅₀ = 11.16 ± 0.84 mg/mL), and superoxide anion (IC₅₀ = 10.33 ± 0.58 mg/mL) assays. Antimicrobial data revealed that single and mixture EOs were active against a panel of pathogenic microorganisms, and the mixture had the ability to kill more bacterial strains than each EO alone. Additionally, the anti-acetylcholinesterase and α-glucosidase inhibitory effect have been studied for the first time, highlighting the high inhibition effect of AChE by C. carvi (IC₅₀ = 0.82 ± 0.05 mg/mL), and especially by C. sativum (IC₅₀ = 0.68 ± 0.03 mg/mL), as well as the mixture (IC₅₀ = 0.63 ± 0.02 mg/mL) compared to the reference drug, which are insignificantly different (p > 0.05). A high and equipotent antidiabetic activity was observed for the mixture (IC₅₀ = 0.75 ± 0.15 mg/mL) when compared to the standard drug, acarbose, which is about nine times higher than each EO alone. Furthermore, pharmacokinetic analysis provides some useful insights into designing new drugs with favorable drug likeness and safety profiles based on a C. carvi and C. sativum EO mixture. In summary, the results of this study revealed that the combination of these EOs may be recommended for further food, therapeutic, and pharmaceutical applications, and can be utilized as medicine to inhibit several diseases.

Diabetes mellitus is a global threat affecting millions of people of different age groups. In recent years, the development of naturally derived anti-diabetic agents has gained popularity. Okra is a common vegetable containing important bioactive components such as abscisic acid (ABA). ABA, a phytohormone, has been shown to elicit potent anti-diabetic effects in mouse models. Keeping its anti-diabetic potential in mind, in silico study was performed to explore its role in inhibiting proteins relevant to diabetes mellitus- 11β-hydroxysteroid dehydrogenase (11β-HSD1), aldose reductase, glucokinase, glutamine-fructose-6-phosphate amidotransferase (GFAT), peroxisome proliferator-activated receptor-gamma (PPAR-gamma), and Sirtuin family of NAD(+)-dependent protein deacetylases 6 (SIRT6). A comparative study of the ABA-protein docked complex with already known inhibitors of these proteins relevant to diabetes was compared to explore the inhibitory potential. Calculation of molecular binding energy (ΔG), inhibition constant (pKi), and prediction of pharmacokinetics and pharmacodynamics properties were performed. The molecular docking investigation of ABA with 11-HSD1, GFAT, PPAR-gamma, and SIRT6 revealed considerably low binding energy (ΔG from −8.1 to −7.3 Kcal/mol) and predicted inhibition constant (pKi from 6.01 to 5.21 µM). The ADMET study revealed that ABA is a promising drug candidate without any hazardous effect following all current drug-likeness guidelines such as Lipinski, Ghose, Veber, Egan, and Muegge.

Foodborne infections caused by bacterial pathogens are a common cause of human illness in the Middle East, with a substantial burden of economic loss and public health consequences. This review aims at elucidating recent literature on the prevalence of Non-Typhoidal Salmonella (NTS), Campylobacter and Listeria monocytogens in the food chain in the Arab countries, and to consolidate available evidence on the public health burden and the status of antimicrobial resistance (AMR) among the concerned three pathogens. The reviewed evidence points to a scarcity of understanding of the magnitude of NTS in the food chain in the Arab countries. Additionally, not much work has been done at the molecular characterization level to address the source-attribution of NTS in the Arab World. Very few surveys have been done on Campylobacter in the food chain in the Gulf Cooperation Council (GCC) countries. There is a gap in quantitative (counts/numbers) surveillance efforts for Campylobacter in the chicken meat supply across all Arab countries, despite the availability of some qualitative (presence/absence) surveillance data. While there are several reports on L. monocytogenes in animal-sourced foods, notably in North African Arab countries, fewer are published on L. monocytogenes in plant-sourced foods. Information on the L. monocytogenes serotypes and strain diversity circulating in the Arab region is widely lacking. Antibiotic resistance in the three pathogens is not fully understood across the Arab region, despite some reports indicating varying trends at the human–food interface. The literature evidence presented in this review stresses that Salmonella, Campylobacter and L. monocytogenes continue to challenge food safety and public health in the Arab countries.

Asphodelus tenuifolius Cav. (A. tenuifolius) is a medicinal plant with a long history of traditional use to treat ailments. In this study, total phenolic and flavonoid content evaluation using LC-ESI/MS analysis and various biological activities (antioxidant, antibacterial, antifungal, antiviral and cytotoxicity) of organic extracts from the aerial parts of A. tenuifolius were analyzed. ADME tools were used to predict the potential of the identified compounds from the most potent extract as specific drugs. As shown, LC-ESI/MS results of chloroformic extract allowed the tentative identification of 12 compounds. Chloroformic extract was rich in polyphenols and flavonoids and exhibited the highest antioxidant activity given by DPPH (IC₅₀ = 25 µg/mL) as compared to the BHT standard (11.5 µg/mL) and β-carotene bleaching assays (IC₅₀ = 95.692 µg/mL). Antibacterial activity results showed that chloroformic extract has a highest activity against Gram-positive and -negative bacteria, especially against Salmonella Typhimurium DT104 (IZ = 19.3 mm, MIC = 18.75 mg/mL, MBC = 37.5 mg/mL). The MBC/MIC ratio was evaluated to interpret the activity that was bacteriostatic rather than bactericidal. Conversely, weaker antifungal activity was registered, and no antiviral activity was observed for all extracts against Herpes Simplex Virus type 2 and Coxsakievirus B-3 viruses. Cytotoxic activity on VERO cell line results revealed that butanol extract was not toxic, with CC₅₀ value of 1430 µg/mL, while chloroformic extract showed moderate cytotoxicity. Additionally, in silico studies performed proved promising pharmacokinetic and drug-likeness properties of the main compounds from the chloroformic extract. Taken together, this work highlights the potent bioactivity and acceptable drug-likeness of this plant, which supports its further preclinical development.

Abelmoschus esculentus (Okra) is an important vegetable crop, widely cultivated around the world due to its high nutritional significance along with several health benefits. Different parts of okra including its mucilage have been currently studied for its role in various therapeutic applications. Therefore, we aimed to develop and characterize the okra mucilage biopolymer (OMB) for its physicochemical properties as well as to evaluate its in vitro antidiabetic activity. The characterization of OMB using Fourier-transform infrared spectroscopy (FT-IR) revealed that okra mucilage containing polysaccharides lies in the bandwidth of 3279 and 1030 cm⁻¹, which constitutes the fingerprint region of the spectrum. In addition, physicochemical parameters such as percentage yield, percentage solubility, and swelling index were found to be 2.66%, 96.9%, and 5, respectively. A mineral analysis of newly developed biopolymers showed a substantial amount of calcium (412 mg/100 g), potassium (418 mg/100 g), phosphorus (60 mg/100 g), iron (47 mg/100 g), zinc (16 mg/100 g), and sodium (9 mg/100 g). The significant antidiabetic potential of OMB was demonstrated using α-amylase and α-glucosidase enzyme inhibitory assay. Further investigations are required to explore the newly developed biopolymer for its toxicity, efficacy, and its possible utilization in food, nutraceutical, as well as pharmaceutical industries.

This paper presents the machinability performance of uncoated, single-coated, and multicoated carbide tools during turning of Grade 5 (Ti6Al4V) Titanium alloy, which is challenging to machine due to its distinctive material properties. Coated tools with single-coated Titanium Aluminium Nitride (TiAlN) and multi-coated layer of Titanium Aluminium Nitride with Aluminium Chromium Nitride (TiAlN + AlCrN) coated inserts were utilized to assess surface roughness (Ra), tool wear rate (R), and chip morphologies under various cutting conditions using dry machining. Analysis of the used tools revealed that coated tools exhibited improved tool life and surface quality compared to uncoated tools across all cutting conditions. Multi-coated tools of TiAlN + AlCrN demonstrated a tool life increase of up to 15% compared to uncoated and single-coated tools, with surface roughness improvements ranging from 30 to 45% depending on cutting speed. Chip morphology analysis indicated an increase in the chip reduction coefficient with higher cutting speeds for all tool types. Coated tools exhibited the lowest chip-reduction coefficient due to the presence of TiAlN and AlCrN coatings, which control the tool chip contact length. Conversely, uncoated chip morphology resulted in larger chip thickness values compared to coated tools, particularly at cutting speeds above 100 m/min, attributed to poor heat dissipation and chemical reactions at the tool chip interface. Energy dispersive X-ray scanning electron microscopy (SEM/EDXS) analysis of worn uncoated inserts revealed a higher tendency towards Titanium adhesion compared to coated tools. The proposed multi-layer coatings of (TiAlN + AlCrN) used for dry machining proved highly beneficial for achieving economic machining objectives and may reduce the need for lubrication when processing Ti6Al4V alloys.