We present spectroscopic measurements focusing on a detailed investigation of temperature dependence of absorption, emission and gain in the uniaxial Yb:YLF laser gain medium. Measurements are carried out in the 78–300 K range, but we especially targeted our attention to the 78–150 K interval, which is the desired working range of liquid nitrogen cooled cryogenic Yb:YLF lasers/amplifiers. A tunable (770–1110 nm) Cr:LiSAF laser with around 100 mW continuous-wave output power and sub-0.2 nm bandwidth is used as an excitation source. The average power of the Cr:LiSAF laser is low enough to prevent heating of the sample, and its spectral flux (W/nm) is high enough to enable large signal-to-noise ratio measurements. Measured absorption data is used to cross-check the validity of the emission measurements, while the measured temperature dependent small-signal gain profile provided a second independent confirmation. The acquired absorption cross section curves match the previous literature quite well, whereas the measured strength of c-axis emission is stronger than some of the earlier reports. Direct measurements of small signal gain confirmed the emission cross section data, where single pass gain values above 50 have been measured for the 995 nm transition of E//c axis at 78 K. We further provide simple analytic formulas for the measured temperature dependence of absorption and emission cross section. We hope the presented results to be useful for the development of next generation of cryogenic Yb:YLF laser and amplifier systems.
The low (sub %) efficiencies so-far demonstrated for nonlinear optical down-conversion to terahertz (THz) frequencies are a primary limiting factor in the generation of high-energy, high-field THz-radiation pulses (in particular narrowband, multicycle pulses) needed for many scientific fields. However, simulations predict that far higher conversion efficiencies are possible by use of suitably-optimized optical sources. Here we implement a customized optical laser system producing highly-tunable trains of infrared pulses and systematically explore the experimental optimization of the down-conversion process. Our setup, which allows tuning of the energy, duration, number and periodicity of the pulses in the train, provides a unique capability to test predictions of analytic theory and simulation on the parameter dependences for the optical-to-THz difference-frequency generation process as well as to map out, with unprecedented precision, key properties of the nonlinear crystal medium. We discuss the agreements and deviations between simulation and experimental results which, on the one hand, shed light on limitations of the existing theory, and on the other hand, provide the first steps in a recipe for development of practical, high-field, efficiency-optimized THz sources.
In this work, we investigate an approach to scale up the output pulse energy in an all-polarization-maintaining 17.3 MHz Yb-doped fiber oscillator via implementation of a 25 µm core-diameter large-mode-area fiber. The artificial saturable absorber is based on a Kerr-type linear self-stabilized fiber interferometer, enabling non-linear polarization rotation in polarization-maintaining fibers. Highly stable mode-locked steady states in the soliton-like operation regime are demonstrated with 170 mW average output power and a total output pulse energy of ∼10nJ distributed between two output ports. An experimental parameter comparison with a reference oscillator constructed with 5.5 µm core-sized standard fiber components reveals an increase of pulse energy by a factor of 36 with simultaneously reduced intensity noise in the high-frequency range >100kHz.
We demonstrate the strong performance enhancement of an all-polarization-maintaining mode-locked fiber oscillator using a linear self-stabilized fiber interferometer via the suppression of the cross-phase modulation (XPM). Numerical simulations reveal that XPM significantly affects the saturable absorber dynamics resulting in strong distortions of the mode-locked steady-states and output pulse quality. For experimental verification, we construct an oscillator with XPM suppression, employing an intra-cavity YVO4 crystal to obtain a differential walk-off effect and compare its characteristics with a reference oscillator in a standard configuration. It is shown, that the XPM suppression not only lowers the mode-locking threshold by more than 45% but further results in improved pulse quality at the output ports and reduced nonlinear loss in the artificial saturable absorber.
We present a diode-pumped Yb:YLF laser system generating 100-mJ sub-ps pulses at a 1-kHz repetition rate (100 W average power) by chirped-pulse amplification. The laser consists of a cryogenically cooled 78 K, regenerative, eight-pass booster amplifier seeded by an all-fiber front end. The output pulses are compressed to 980 fs in a single-grating Treacy compressor with a throughput of 89%. The laser will be applied to multi-cycle THz generation and pumping of high average power parametric amplifiers.