This article presents a numerical and experimental investigation of the flow inside an ultra-compact, serpentine inlet duct. The numerical analysis used two flow solvers: FLUENT®, a commercial code, and UNS3D, an in-house code. The flow was modelled using the Reynolds-averaged Navier-Stokes equations. The turbulence effects were modelled by using the shear-stress transport k–ω model. The numerical investigation was compared against experimental data obtained in an open-circuit, low-speed wind tunnel in the Fluid Dynamics Laboratory at Texas A&M University. The numerical simulations and experimental testing were performed to reveal the separation points and the strong secondary flow phenomena within the inlet. UNS3D overpredicted the location of the first separation point by 9 mm and the location of the second separation point by 1 mm, while the area-averaged pressure loss coefficient was 5% higher than in the experiment. The numerical results of UNS3D agreed better with the experiment than those of FLUENT.
A reduced-order model based on the proper orthogonal decomposition (POD) method is used to assess whether it can predict the highly unsteady flow in turbomachinery cascades. Three cases are considered: a transonic fan rotor called the National Aeronautics and Space Administration Rotor 67, a cascade of oscillating compressor blades called the 10th Standard Configuration, and a cascade of oscillating turbine blades called the 11th Standard Configuration. The governing equations used in this POD model, called zeta-POD, are written using the specific volume instead of density. This formulation of the governing equations allows the precomputation of the coefficients of the system of ordinary differential equations prior the flow simulation. Consequently, a significant speedup is obtained compared to the full-order model and a traditional, density-based POD. In addition, the accuracy of the zeta-POD model is compared against the full-order model and the density-based POD.
29 October 2010 in Journal of Engineering for Gas Turbines and Power
A Reynolds-averaged Navier–Stokes (RANS) solver developed in-house was used to simulate grazing channel flow past single and multiple cavities. The objective of this investigation was to predict fluid instabilities in hole-pattern stator seals. The numerical results generated with the RANS solver showed good agreement with those obtained using a commercial large eddy simulation code. In addition, the numerical results agreed well with experimental data. Rossiter’s formula, a popular semi-empirical model used to predict frequencies of hole-tone acoustic instabilities caused by grazing fluid flow past open cavities, was modified using the RANS solver results to allow for its application to channel flows. This was done by modifying the empirical constant , the ratio of vortex velocity, and the freestream velocity. The dominant frequencies predicted using Rossiter’s formula with the new value matched well with the experimental data for hole-pattern stator seals. The RANS solver accurately captured the salient features of the flow/acoustic interaction and predicted well the dominant acoustic frequencies measured in an experimental investigation. The flow solver also provided detailed physical insight into the cavity flow instability mechanism.