The neutronics performance of a tokamak has been identified as an important factor in designing a fusion power plant. The design of the tokamak should not only meet operational parameters such as sufficient tritium breeding, but also safety parameters such as low structural material activation. This paper investigates the impacts of the neutronics metrics for the ARC-class tokamak, a compact tokamak with an immersion blanket, by perturbing the first five layers of structural material—first wall, inner vacuum vessel, coolant salt channel, neutron multiplier, and outer vacuum vessel. The goal of this work is to provide insight into shaping and scaling the flux on each layer to obtain optimized operational and safety metrics through quantification of the responses from each perturbation. Results show that increased first wall thickness can increase the tritium breeding ratio (TBR) in specific configurations with high 6Li enrichments and that vacuum vessels decrease TBR for low-6Li enrichment configurations. It was also found that the neutron multiplier can either increase or decrease TBR depending on the configuration. The response of metrics to the change in layer thickness and enrichment also varies depending on the vacuum vessel material. The integral impacts of 6Li enrichment, layer thicknesses, and vacuum vessel material choice are investigated and presented in this paper.
Fusion neutronics calculations provide important metrics pertinent to fusion device operations, such as tritium breeding ratios (TBRs) and data on heat deposition, material activation, and damage. Because of the high computational burden required to generate a high-fidelity Monte Carlo simulation of a 3D fusion device, various assumptions are made to reduce computational time by simplifying the reactor model or the calculation iteration. This paper explores the impact of fusion neutronics metrics such as the TBR and decay heat of structural materials based on assumptions of material composition in the fusion reactor and temperature modeling of materials. Results show that for compact tokamaks with high power and long operational cycles, the transmutation of structural materials is significant enough to cause a substantial change in the flux spectrum and decrease the TBR by 1.68% after 2 years of full power operation. Additionally, assuming a constant temperature and material density can impact the TBR calculations up to 3%.