Software-Defined Networking (SDN) is a new paradigm that revolutionizes the idea of a software-driven network through the separation of control and data planes. It addresses the problems of traditional network architecture. Nevertheless, this brilliant architecture is exposed to several security threats, e.g., the distributed denial of service (DDoS) attack, which is hard to contain in such software-based networks. The concept of a centralized controller in SDN makes it a single point of attack as well as a single point of failure. In this paper, deep learning-based models, long-short term memory (LSTM) and convolutional neural network (CNN), are investigated. It illustrates their possibility and efficiency in being used in detecting and mitigating DDoS attack. The paper focuses on TCP, UDP, and ICMP flood attacks that target the controller. The performance of the models was evaluated based on the accuracy, recall, and true negative rate. We compared the performance of the deep learning models with classical machine learning models. We further provide details on the time taken to detect and mitigate the attack. Our results show that RNN LSTM is a viable deep learning algorithm that can be applied in the detection and mitigation of DDoS in the SDN controller. Our proposed model produced an accuracy of 89.63%, which outperformed linear-based models such as SVM (86.85%) and Naive Bayes (82.61%). Although KNN, which is a linear-based model, outperformed our proposed model (achieving an accuracy of 99.4%), our proposed model provides a good trade-off between precision and recall, which makes it suitable for DDoS classification. In addition, it was realized that the split ratio of the training and testing datasets can give different results in the performance of a deep learning algorithm used in a specific work. The model achieved the best performance when a split of 70/30 was used in comparison to 80/20 and 60/40 split ratios.
Due to the unprecedented growth in mobile data traffic, emerging mobile access networks such as fifth-generation (5G) would require huge bandwidth and a mobile fronthaul architecture as an essential solution in providing a high capacity for support in the future. To increase capacity, utilizing millimeter waves (mm-waves) in an analog radio over fiber (RoF) fronthaul link is the major advancement and solution in achieving higher bandwidth and high data rate to cater for 5G mobile communication. In this paper, we demonstrate the feasibility of transmission and reception of a 100 Gbits/s data rate link at 28 GHz. The performance of three modulation formats (16-PSK, 16-QAM and 64-QAM) have been compared for an optical fiber length from 5 km up to 35 km for two detection systems; coherent and direct detection. Also, in this paper, the transmission impairments inherent to transmission systems are realized through the implementation of a digital signal processing (DSP) compensation scheme in the receiver system to enhance system performance. Quality factor (QF) and bit error rate (BER) are used as metrics to evaluate the system performance. The proposed system model is designed and simulated using Optisystem 16.