The geometrical effects of filtering channels in a CTC microfilter have been studied. Pressure signatures and cell deformation have been characterized using numerical modeling.
Circulating tumor cells (CTCs) separation technology has made positive impacts on cancer science in many aspects. The ability of detecting and separating CTCs can play a key role in early cancer detection and treatment. In recent years, there has been growing interest in using deformability-based CTC separation microfilters due to their simplicity and low cost. Most of the previous studies in this area are mainly based on experimental work. Although experimental research provides useful insights in designing CTC separation devices, there is still a lack of design guidelines based on fundamental understandings of the cell separation process in the filters. While experimental efforts face challenges, especially microfabrication difficulties, we adopt numerical simulation here to study conical-shaped microfilters using deformability difference between CTCs and blood cells for the separation process. We use the liquid drop model for modeling a CTC passing through such microfilters. The accuracy of the model in predicting the pressure signature of the system is validated by comparing it with previous experiments. Pressure-deformability analysis of the cell going through the channel is then carried out in detail in order to better understand how a CTC behaves throughout the filtration process. Different system design criteria such as system throughput and unclogging of the system are discussed. Specifically, pressure behavior under different system throughput is analyzed. Regarding the unclogging issue, we define pressure ratio as a key parameter representing the ability to overcome clogging in such CTC separation devices and investigate the effect of conical angle on the optimum pressure ratio. Finally, the effect of unclogging applied pressure on the system performance is examined. Our study provides detailed understandings of the cell separation process and its characteristics, which can be used for developing more efficient CTC separation devices.
Models of a droplet passing through narrow constrictions have wide applications in science and engineering. In this paper, we report our findings on the minimum impulse (momentum change) of pushing a droplet through a narrow circular constriction. The existence of this minimum impulse is mathematically derived and numerically verified. The minimum impulse happens at a critical velocity when the time-averaged Young-Laplace pressure balances the total minor pressure loss in the constriction. Finally, numerical simulations are conducted to verify these concepts. These results could be relevant to problems of energy optimization and studies of chemical and biomedical systems.
The model of a droplet squeezed through a narrow-constricted channel has many applications in pathology, chip/filter/membrane design, drug delivery, etc. Understanding the transient physics of the squeezing process is important in the design and optimization of many micro flow systems. However, available models often ignore the influence of droplet viscosity, and they usually feature low numerical efficiency by solving Navier-Stokes equations. In the present research, we developed a low-dimension analytical model to predict the pressure of squeezing a viscous droplet through a circular constricted channel with acceptable fidelity and low computational cost. Our approach is as follows. We first adapt the Hagen–Poiseuille law to predict the viscosity effect of droplet squeezing. Next, we obtain an analytical expression for the extra pressure caused by only the curvature change obtained. Finally, the general expression of squeezing pressure taking consideration of viscosity and surface tension is expressed. The analytical model we developed is in great agreement with the numerical solutions of the Navier-Stokes equation at a low Reynolds number and low capillary number. These findings have fundamental significance for future applications in engineering and industry.