This research investigated the transient saltwater upconing in response to pumping from a well in a laboratory-scale coastal aquifer. Laboratory experiments were completed in a 2D flow tank for a homogeneous aquifer where the time evolution of the saltwater wedge was analysed during the upconing and the receding phase. The SEAWAT code was used for validation purposes and to thereafter examine the sensitivity of the critical pumping rate and the critical time (the time needed for the saltwater to reach the well) to the well design and hydrogeological parameters. Results showed that the critical pumping rate and the critical time were more sensitive to the variations of the well location than the well depth. The critical time increased with increasing the location and depth ratios following a relatively linear equation. For all the configurations tested, the lowest critical pumping rate was found for the lower hydraulic conductivity, which reflects the vulnerability of low permeability aquifers to salinization of pumping wells. In addition, higher saltwater densities led to smaller critical pumping rate and shorter critical time. The influence of the saltwater density on the critical time was more significant for wells located farther away from the initial position of the interface. Moreover, increasing the dispersivity induced negligible effects on the critical pumping rate, but reduced the critical time for a fixed pumping rate.
Subsurface physical barriers are amongst the most effective methods to mitigate seawater intrusion in coastal aquifers. The main objective of this study was to examine the impact of cutoff walls on saltwater upconing using laboratory and numerical modelling experiments. Physical experiments were first completed to reproduce the saltwater upconing process in a laboratory-scale coastal aquifer model incorporating an impermeable cutoff wall. Numerical modelling was used for validation purposes and to perform additional simulations to explore the protective effect of cutoff walls against saltwater upconing. The results suggest that the cutoff wall did not substantially delay the saltwater upconing mechanism in the investigated configurations. Laboratory and numerical observations showed the existence of some residual saline water, which remained on the upper part of the aquifer on the seaward side of the wall following the retreat of the saltwater. The protective effect of cutoff walls was noticeably sensitive to the design parameters. Specifically, cutoff walls installed close to the pumping well enabled the implementation of higher pumping rates, therefore a more optimal use of the freshwater, especially for deeper wells. The results highlighted that the penetration depth of the cutoff walls may not necessarily need to exceed the depth of the pumping well to ensure effectiveness, which is of great importance from construction and economic perspectives.
Laboratory and numerical experiments were conducted to provide a quantitative steady-state analysis of the effect of incremental variations of water level on saltwater intrusion. The purpose was to seek mathematical correlations relating both the wedge toe length and the height along the coastline to the boundary head difference. The laboratory experiments were completed in a 2D sand tank where both freshwater and seawater levels were varied. The experiments were conducted for two bead sizes having different hydraulic conductivities. The numerical model SEAWAT was used to validate the results and then to perform sensitivity analysis. The experimental results show that at steady-state conditions, the logarithmic toe length could be expressed as a linear function of the boundary head difference. The linear relationship was recorded in both advancing and receding wedge phases. The linearity of the correlation was also well demonstrated with analytical solutions. Similar relationships were also derived in the scenarios where the sea level fluctuated while the freshwater boundary head was constant. The height of the saltwater wedge along the coastline was also found to be a linear function of the boundary head difference. The sensitivity analysis shows that the regression coefficients were sensitive to the hydraulic conductivity, the dispersivity, and the saltwater density, while the porosity and the rate of boundary head change induced negligible effects. The existence of a linear relationship between the logarithmic toe length and the boundary head difference was also well evidenced in a field-scale aquifer model for all the different hydrogeological aquifer conditions tested. This study is the first attempt in identifying the underlying correlation between the boundary water level variations and the main seawater intrusion (SWI) external metrics under controlled laboratory conditions, which is of great relevance from a water resources management perspective.