Global path planning remains a critical challenge in mobile robots, with ant colony optimization (ACO) being widely adopted for its swarm intelligence characteristics. To address the inherent limitations of ACO, this study proposes an intelligently enhanced ACO (IEACO) incorporating six innovative strategies. First, the early search efficiency is improved by implementing a non-uniform initial pheromone distribution. Second, the -greedy strategy is employed to adjust the state transition probability, thereby balancing exploration and exploitation. Third, adaptive dynamic adjustment of the exponents and is realized, dynamically balancing the pheromone and heuristic function. Fourth, a multi-objective heuristic function considering both target distance and turning angle is constructed to enhance the quality of node selection. Fifth, a dynamic global pheromone update strategy is designed to prevent the algorithm from prematurely converging to local optima. Finally, by introducing multi-objective performance indicators, the path planning problem is transformed into a multi-objective optimization problem, enabling more comprehensive path optimization. Systematic simulations and experimentation were performed to validate the effectiveness of IEACO. The simulation results confirm the efficacy of each improvement in IEACO and demonstrate its performance advantages over other algorithms. The experimental results further highlight the practical value of IEACO in solving global path planning problems for mobile robots.
A data-driven aerodynamic modeling method is proposed to address the problem that traditional modeling methods based on physical mechanisms cannot fully represent the special aerodynamic characteristics of tiltrotor evtol aircraft. By analyzing the uniquely complex aerodynamic characteristics of electric vertical take-off and landing (evtol) aircraft, an MLP neural network model has been constructed that reflects the coupling characteristics between influencing factors. Using the XV15 wind tunnel test data, a dataset was constructed, and the neural network model was trained and validated. Simulation results show that the selected data-driven method can accurately predict the aerodynamic characteristics of the longitudinal transition phase of the tiltrotor evtol.
In the design of the six degrees of freedom (6-DOF) flight simulation system, the unmodeled dynamic, transient performance and steady-state performance of the system are generally concerned. Considering that the model of flight simulation system is highly nonlinear and requires high response speed and high stability, this paper applies adaptive controller to the control of flight simulation platform. The controller has a low-pass filter in feedback loop to avoid high frequencies in the control signals, and the required transient performance can be enhanced by increasing the adaptive gain, which can improve the transient, stability, and smoothness of the flight simulator platform. The performance of the adaptive controller is obtained by comparison with the traditional model reference adaptive controller (MRAC). In addition to maintaining the good transient response of MRAC, the adaptive controller improves the stability of the system. The output amplitude of the actuator is reduced by 39.95%, which effectively reduces the performance requirements of the actuator. Some additional experimental evaluations are carried out to show the performance of the controller.
Electric tilt-wing flying cars are an efficient, economical, and environmentally friendly solution to urban traffic congestion and travel efficiency issues. This article addresses the high energy consumption and obstacle interference during the takeoff phase of the tilt-wing eVTOL (electric Vertical Takeoff and Landing), proposing a trajectory planning method based on energy minimization and obstacle avoidance. Firstly, based on the dynamics analysis, the relationship between energy consumption, spatial trajectory, and obstacles is sorted out and the decision variables for the trajectory planning problem with obstacle avoidance are determined. Secondly, based on the power discretization during the takeoff phase, the energy minimization objective function is established and the constraints of performance limitations and spatial obstacles are derived. Thirdly, by integrating the optimization model with the SLSQP (Sequential Least Squares Quadratic Programming algorithm), the second-order sequential quadratic programming model and decision variable update equations are derived, establishing the solution process for the trajectory planning problem of the tilt-wing eVTOL takeoff with obstacle avoidance. Finally, the Airbus Vahana A3 is taken as an example to verify and validate the effectiveness, stability, and robustness of the model and optimization algorithm proposed. The validation results show that the OTPEM (obstacle avoidance trajectory planning methodology based on energy minimization) can effectively handle changes in the takeoff end state and exhibits good stability and robustness in different obstacle environments. It can provide a certain reference for the three-dimensional obstacle avoidance trajectory planning of Airbus Vahana A3 and other tilt-wing eVTOL trajectory planning problems.
As the control input of the virtual reality flight simulator, precise head tracking with no time-delay is essential for user immersion and training effect. We present the results of applying a modified Kalman filter to improve head orientation prediction. A piecewise constant acceleration approach with an electromyography based input estimation is suggested. Head angular acceleration is estimated by a trained feed-forward neural network and fed into the modified Kalman filter. Experimental results show that the proposed method tracks head motion precisely under both smooth and abrupt motion conditions.
Virtual reality environments play an important role in flight safety research, such as in the reconstruction of aircraft accidents. Head Mounted Display (HMD) systems now measure head motion with traditional kinematic sensors. In this way, head motion can only be detected when it has already happened and its update rate is limited, which results in time-lag and simulation sickness. This paper investigates the possibility and feasibility of fusing surface electromyogram (sEMG) bio-signals and traditional inertial gyro data to deal with the time lag problem which commonly exists in HMD based virtual environment applications. Five features are extracted from the sEMG signal to input into a trained RBF neural network, which is designed to fuse sEMG features and inertial data to anticipated head motion. Experimental results show that biotechnology will be a promising tool for virtual reality human-computer interaction.